1.
The Measuring Method & Application of Cylinder Bolts Extension for Assembling
汽轮机汽缸中分面螺栓伸长量测量方法及应用
2.
The expansion of the steam in the cylinder causes some of the steam to condense. (=When the steam expands in the cylinder some of the steam condenses.)
蒸汽在汽缸中膨胀时，部分蒸汽冷凝。
3.
Loss analysis in aerodynamic design of mid-pressure-cylinder of steam turbine
汽轮机中压缸气动设计中的损失分析
4.
Market Analysis of FAW Medium & Heavy Cylinder Block Project;
一汽中重型缸体铸件项目的市场分析
5.
Preventing Water into the Cylinder During Turbine Starting
汽轮机启动过程中汽缸入水原因分析及预防
6.
cylinder wall surface temperature transducer
汽缸壁表面温度发送器
7.
The Calculation and Error Analysis for HP-IP Midspan Packing Leakage in Steam Turbines
高中压合缸分隔轴封漏汽计算方法与误差分析
8.
Remove the engine cylinder head from the cylinder block (refer to cylinder head removal in this section).
从汽缸体拆下引擎汽缸盖（请参阅本部分之汽缸盖拆卸）。
9.
Analyses and Control of Expansion Difference in 300 MW High-Medium Pressure Cylinders of Steam Turbines
300MW汽轮机高中压缸胀差变化原因分析及控制
10.
a bank of cylinders in an engine
发动机中的一排汽缸
11.
A charge of gas is compressed inside the chamber .
一次进汽在汽缸里面受到压缩。
12.
Remove cylinder head cover, refer to cylinder head cover removal in this section.
拆下汽缸头盖，请参阅本节中的汽缸头盖的拆卸。
13.
Aerodynamic Performance Analysis of Turbine Stage with Labyrinth Gland in Intermediate Pressure Cylinder of Steam Turbine
汽轮机中压缸迷宫式汽封完整级气动性能的分析
14.
Clean the exhaust manifold and cylinder head mating surfaces.
清洁排气歧管和汽缸头配合面。
15.
Reason Analysis and Treatment of Shaft-packing Leakage for Turbine High and Medium Pressure Cylinder in Xixia Thermal Power Plant
西夏热电厂汽轮机高、中压缸轴封异常泄漏的原因分析和处理
16.
Analysis of start-up through IP cylinder and its fault treatment for 600 MW super-critical unit
600MW超临界机组汽轮机中压缸启动及故障分析处理
17.
Moto parts major in Iveco fitting，C.V boot, flasher, Distributor cap, Gasket and so on.
汽配方面主要有白金、防尘套、闪光器、汽缸垫等。
18.
Install cylinder head, intake manifold, and exhaust manifold, refer to cylinder head installation in this section.
安装汽缸盖，进气歧管和排气管，请参阅本部分的汽缸盖安装。