1.
Analysis of Multi-axis Synchronized Motion Systems Based on Virtual Line-shaft Control
基于虚轴法控制的多轴同步运动系统分析
2.
Dynamic Method to Calculate for Shaft Center Trajectory of Bearing of Internal Combustion Engine
求解内燃机曲轴—轴承轴心轨迹的动力学方法
3.
New inference method of the optic axial angle and the ray axial angle of the negative biaxial crystal
负双轴晶体光轴角和光线轴角推导的新方法
4.
Analysis of Axial Stiffness of Permanent Magnet Bearings by Using the Equivalent Surface Currents Method
基于分子电流法轴向永磁轴承轴向刚度的分析
5.
Torsional vibration of crankshaft systems--Measurement and evaluation method
GB/T15371-1994曲轴轴系扭转振动的测量与评定方法
6.
Calculation Method Research of the Interference Fit for High Speed Motorized Spindle Bearings
高速电主轴轴承配合过盈量的计算方法研究
7.
Study on Load Analysis Method for Diesel Engine Crankshaft Main Bearing Based on ADAMS;
基于ADMAS的柴油机曲轴主轴承载荷分析方法研究
8.
The Performance Analysis of Diesel Crankshaft and the Research for Calculation Method of Crankshaft Fatigue Strength;
柴油机曲轴性能分析及曲轴强度计算方法研究
9.
Study on Dynamic and Control Methods of Altra-precision Gas Magnetic Bearing Shafting;
超精密气磁轴承轴系动力学及控制方法的研究
10.
Research on Analysis of Shaft Bending Accident and Straightening Method for Turbo-Generator;
汽轮发电机组弯轴事故分析及直轴方法研究
11.
Five-axis Tool Orientation Optimization Based on Kinematical Method
自由曲面五轴加工刀轴矢量的运动学优化方法
12.
The large scale bend axis piston pump axial setting and pump package centre adjusting method
大型斜轴泵轴线设置与泵组中心调整方法
13.
Research and Application on the Tool-axis Vector Control during the 5-axis CNC Programming based on MasterCAM 9.0
基于MasterCAM 9.0五轴编程刀轴矢量控制方法及应用
14.
Research on Position Alignment Method of a Three-axis Simulator
三轴转台三轴交汇中心位置对准方法的研究
15.
Abbot dyeing process
艾博特染色法（多孔轴芯染色法）
16.
Rolling bearing--Identification code
GB/T272-1993滚动轴承代号方法
17.
Spherical plain bearings Identification code
GB/T304.2-1988关节轴承代号方法
18.
testing method for leakage tendencies of automotive wheel bearing lubricating greases
汽车轮股轴承润滑脂泄漏度测定法