1.
tow-to-sliver break spinning
丝束牵切成条纺纱法
2.
Ring-spinning frames for direct spinning
丝束直接纺纱用环锭纺纱机
3.
The Study on the Yarn Structure and Yarn Formation Based on Solospun;
基于单须条分束纺的纱结构及成纱机理
4.
Influence and Discussion of Back Zone Draft on Yarn Quality in Spinning
纺纱过程中后区牵伸对成纱质量的影响浅析
5.
Mechanism of generation of drafting waves during spinning and the way to eliminate it
纺纱牵伸波的产生机制及其消除方法
6.
garnett wires for worsted spinning
精纺毛纱用garnett丝
7.
On Development of Drafting Technology for Cotton Spinning System and Yarn Evenness Quality in China
我国棉型纺纱牵伸工艺与纱条均匀质量的发展方向
8.
A roving is made and then drawn to a fine strand.
先制成纤维条子,再将其牵伸成细纱线。
9.
"Spinning is the process of drawing out and twisting a mass of cleaned, prepared fibres. Filament yarns generally require less twist than do staple yarns."
纺纱是对纤维集合体牵伸加捻的过程。长丝比短纤维需要的捻度少。
10.
drawing [pre-spinning process]
并条〔纺纱前工序〕
11.
a candy made by spinning sugar that has been boiled to a high temperature.
糖煮到高温时，抽出丝来像纺纱一样纺成的一大团丝糖。
12.
The Study of Ca～(2+) Activation on the Enzymatic Degumming of Ramie and the Techniques of Ramie High Count Yarn Stretch-breaking Process;
苎麻生物酶Ca～（2+）激活脱胶及高支纯苎麻纱牵切纺的研究
13.
After combing, the comb sliver is drafted or drawn to form a roving, which is delivered to a spinning frame where the final worsted yarn is made.
经精梳机后,精梳毛条再去被牵伸成粗纱,粗纱再由细纱机加工。最终的纱线在细纱机上生成。
14.
Use of excessive draft in spinning preparatory and ring frames.
在纺纱预备阶段和纺纱设备使用大的牵伸。
15.
A staff that holds on its cleft end the unspun flax, wool, or tow from which thread is drawn in spinning by hand.
（手工）纺纱杆在杆的开裂的一端夹有未纺的亚麻、羊毛或丝束，手转动木杆，线从中纺出
16.
Textiles--Testing method for unevenness of textile strands--Using capacitance testing equipment
GB/T3292-1997纺织品纱条条干不匀试验方法电容法
17.
Acetate staple is now produced by cutting the continuous filaments into short lengths. The staple length is chosen to blend suitably with other fibers in making mixed yarns.
醋酯短纤维可以通过切断连续长丝而获得。短纤维的长度应能适于与其它纤维混纺制成混纺纱线。
18.
The conversion of nylon chips into fiber comprises two distinct processes: spinning and drawing.
从尼龙切片到纤维的转化包括两个不同的过程：纺丝和牵伸。