1.
tyre valve hole misalignment
轮胎气门嘴孔位置不正
2.
A line of punch positions parallel to the shorter edges of a punch card.
平行于穿孔卡短边的一行穿孔位置。
3.
INFLUENCE OF HOLE POSITION ON BENDING RIGIDITY OF UD-LAMINATE
穿孔位置对单向层板弯曲刚度的影响
4.
Measuring and Controlling the Position Error of Bearing Hole in Machining Canular Forked Shaft;
叉头套轴承孔位置误差的测量与控制
5.
Numerical Optimization of Iodine Injector Position for Chemical Oxygen Iodine Laser
氧碘化学激光入碘孔位置的数值优化
6.
Approach to Measuring Coordinate and True Position of Holes by Three-axis Programming;
三坐标编程测量孔及孔位置度方法的探讨与实践
7.
When it has been decided where we are going to drill, we put up at the surface an oil derrick.
决定了钻孔位置后，我们就在地面上竖起井架。
8.
A line of punch positions parallel to the Y datum line of a punch card.
和卡片的Y基准线平行的一行穿孔位置。
9.
(3) Near the midchord, the suction can provide a higher lift force for the airfoil.
(3)吸气孔位置在翼面的中部附近增升效果较好;
10.
Mark location of the holes for the opposite leg and drill three more holes.
标注出对面支柱的孔洞位置,并打钻出三个孔。
11.
Punching is done with a special punch-register device.
打孔是用一种专用的打孔定位装置进行的。
12.
Observation on the position relation among supraorbital foramen,infraorbital foramen and anterior maxillary foramen of Chinese with 64-lamella CT
64层CT扫描观察国人眶上孔、眶下孔、颏孔的位置关系
13.
Observation on the positional relationship among supraorbital foramen,infraorbital foramen and anterior maxillary foramen of Chinese with 64-row CT
64层螺旋CT三维重建观察国人眶上孔、眶下孔、颏孔的位置关系
14.
Detection of location Accurary of Holes and Design Analysis on Gage
孔组位置度检验及其量规的设计分析
15.
The Mode Analysis and Position Selection of Perforated Panel Absorber
穿孔板吸声结构模态分析及位置选择
16.
Punch register system: Device which punches registered holes in sets of films or plates for positioning purposes.
打孔定位系统:在一套菲林片或版片上打定位小孔，以确定位置的装置。
17.
A. Position the bores according to the product. Drill φ 6 bores respectively with impact driller, after the center line for bolt bore is drawn in the appropriate position on the wall.
根据产品安装孔位，在墙面相应位置画出螺钉孔中心线后，用冲击钻分别钻φ6孔。
18.
The dimension and position of the holes of perforated paper tape for information processing exchange
GB/T1990-1980信息处理交换用穿孔纸带孔的尺寸与位置