1.
Finite Element Analysis of Liquid-end Valve-seat of F-1300 Pump
F-1300型泥浆泵液力端阀座有限元分析
2.
The valve's seat is at the opposite end from the handle.
阀门的阀座位于手柄对面的另一端。
3.
Test ports shall have internal check valve and be equipped with caps.
测试端口应该内置止回阀并配置阀盖。
4.
The valves can used for pipe nozzle and have reliable performance.
阀门可用于管端作放空阀用，性能可靠。
5.
Insert stem/ball into stem boss from inside body with ball rotated to align port with waterway.
将球体旋转对准水路端口，从阀体内将阀杆/球体插入阀杆轮箍内。
6.
The flow through gate valves can be from either end.
流体可以从闸阀的任一个端口流入。
7.
Remove the service valves and cap the compressor ports.
卸去维修阀门，并盖住压缩机端口。
8.
"The relief valve discharge line should terminate 6"above a suitable open drain."
安全阀排泄管终端距离地漏高度为152mm。
9.
NOTE: INSPECT VALVE BLOCK ASSY FOR ANY BACKED OUT TERMINALS.
注意：为任何旋出的端子检查阀组件。
10.
Wars between Warlords in Jiangsu and Zhejiang and Inchoation of Shanghai Special Administrative City
江浙军阀战争与上海特别市的发端
11.
On Design of Spring in Venturi Terminal Variable Air Valve
文丘里型末端变风量阀弹簧设计探讨
12.
High Speed On-off Valve PWM Control Cylinder System with Closed Terminal
PWM阀控单端封闭气缸系统的工作
13.
Open needle valve" A" high side and vent needle valve to vent air from bypass hose.
开启针形阀“A”高端和排气针形阀，从旁路软管排放空气。
14.
Place the cover onto the spring with the internal guide on the cover positioned inside the end coil.
将阀盖及阀盖上的内部引导放置在弹簧上，定位内部端线圈。
15.
The line pressure required to open the valve is a function of the disc/piston weight and the size of the port diameter.
开启阀门所需要的管道压力取决于阀瓣／活塞的重量和阀门端口直径的综合作用。
16.
Remove stem nuts (22). Keep stem from turning by inserting screw driver in slot on end of stem.
拆卸阀杆螺母(22)。通过在阀杆末端的槽内插入螺丝刀来避免阀杆旋转。
17.
Port closure directly proportional to stem travel for throttling.
端口关闭与阀杆运动成正比例，适用于节流。
18.
The opposite end is tapered to a small opening that is threaded to accommodate the installation of a valve.
另一端是锥形开口，车有螺纹，以便安装阀门。