1.
The switchback operation returns the ACTIVE RCSs to the ACTIVE state on their primary AP.
恢复切换操作将会使其主 AP 上的 ACTIVE RCS 回复为 ACTIVE 状态。
2.
The following programs may cause the version switch operation to fail. It is highly recommended that you close this programs before you continue.
下列程序可能引起版本切换操作失败。建议您在继续操作之前关闭这些程序。
3.
No diagnostics are performed as part of a restore operation.
恢复操作并不执行任何诊断。 切换 RCS
4.
Attempting to switch a non-Switcher or improperly-typed behavior
试图切换到非转换程序或不适当的键入操作
5.
Task Manager is minimized when a SwitchTo operation is performed
在执行“切换至”操作时任务管理器最小化
6.
Switch from one operating system's Help content to another
从一个操作系统的帮助内容切换到另一个
7.
Are you sure you want to switch to advanced mode. This action can not be undone.
您是否确认要切换到高级模式? 此操作无法撤消。
8.
After RCSs are switched, the remove operation removes the DS1 connection.
在切换 RCS 之后，退出服务操作会删除 DS1 连接。
9.
Design and Implementation of Switch System to Standard I/O Devices of Operating and Expressing Machines;
操作表示机标准I/O设备切换系统设计与实现
10.
Analysis on Relay Protection Change-over during By-pass Substitution Operation in 220 kV Transmission Line
220kV变电站旁路代送线路操作继电保护切换分析
11.
A conditional remove operation command switches over only the RCSs that can be switched without dropping stable calls.
有条件退出服务的操作命令仅切换那些不用中断稳定呼叫就可切换的 RCS。
12.
The process of switching from one task to another in a multitasking operating system.
在多任务操作系统中我一个任务切换到另一个的过程。
13.
Operational Guidelines for School Official Cites Use of Mobile : Direction, M, N Key Switch weapons. Key box attacks.
操作指南：方向键移动，m、n键切换武器.空格键攻击。
14.
Operation of the ASU employing freezing process with reversing heat exchangers after the upper column being transformed into the packed column
切换冻结流程空分设备上塔改为填料塔后的操作
15.
Control panel is showed as LCD,which light touching the key operate,whole Chinese-English interface,It's easy to operation.
控制面板采用大屏幕液晶屏显示，轻触式按键操作，中英文图形化界面切换，操作直观、简便。
16.
The requested transformation operation is not supported.
不支持请求的变换操作。
17.
Overflow In conversion or arithmetic operation
转换或算术操作溢出
18.
This operation will first switch to the top frame of the call stack and then set the next statement to a different function. Are you sure?
该操作将首先切换到调用堆栈的顶桢，然后将下一条语句设置为其他函数。确实要这样做吗？