1.
"When the crankshaft is removed, it is the usual procedure to clean out the oil passages in the crankshaft."
拆卸曲轴时,通常应该清洁曲轴油道。
2.
valve rocker shaft oil pipe adapter
气门摇臂轴油管接头
3.
Install new front crankshaft oil seal.
安装新的前曲轴油封。
4.
Shaft Assembly (Male, female, washer, grease….
轴组件（轴，轴套，轴承，油脂。。。）
5.
groove-cutting chisel
槽刨, 油槽铲(轴承)
6.
spindle inner oil seal
(平衡器) 轴内油封
7.
shaft-driven oil pump
主轴(驱动的)油泵
8.
emergency bearing oil pump
紧急备用轴承油泵应急轴承油泵
9.
Analytical Investigation on Strength and Main Bearing Lubrication of CA4D32 Diesel Engine Crankshaft System Based on a Simulation Technique;
柴油机曲轴轴系强度和主轴承润滑仿真研究
10.
Analysis of Alignment of Shaft-core Line Between Crankshaft of Marine Diesel and Thrust Shaft
船舶柴油机曲轴与推力轴轴线校中分析
11.
In rotating, the shaft splashes oil up into the bearings.
当轴旋转的时候就把油溅入轴承。
12.
Application of Oil-free Lubricating Material to Long Shaft Bearings for Dog Transfer
拨入机长轴轴承无油润滑材料的应用
13.
The Study on Running-in and Wear Properties of Crankshaft-bearing Shell of Diesel Engine
柴油机曲轴-轴瓦磨合磨损性能研究
14.
graphited oilless bearing
石墨润滑的无油轴承
15.
axial double-tilting frame type oil motor
轴向双斜盘式油马达
16.
bearing oil interface
轴承与润滑油的接触面
17.
low bearing oil pressure alarm
轴承油压下降警报器
18.
crankcase oil foaming
曲轴箱润滑油起泡沫