1.
Turn the wiper module over and remove the nut that secures the wiper motor crank arm to the wiper motor output shaft.
转动雨刷模组盖，并拆下将雨刷马达曲柄臂固定于雨刷马达输出轴上的螺帽。
2.
Using Mathcad to analyze and calculate the track of bell-crank rocker type plate turnover machine
利用Mathcad求解双臂曲柄摇杆式翻板机运动轨迹
3.
Return Offset U
形管（俗名遮柄曲）
4.
The crank is an offset section of the crankshaft.
曲柄是曲轴的偏置部分。
5.
Disconnect the handle-to-latch rod from the handle latch release lever arm.
从手柄-锁闩释放连杆臂上断开手柄-锁闩的连杆。
6.
Thai type pipe wrench with double-curved handle
泰式双曲柄管子扳钳
7.
Screw, crank cover
曲柄轴盖子固定螺丝
8.
slider crank chain
滑块曲柄链系(机构)
9.
To provide with a handle that is used in turning.
给…装上用于转动的曲柄
10.
The nurse cranked up the bed
护士用曲柄把床摇起。
11.
No Crank Sensr Learn
（无曲柄感知器信息）
12.
maneton clamp bolt
可拆卸曲柄颊夹紧螺栓
13.
steering clutch release crank axle
转向离合器开关曲柄轴
14.
reel height adjusting crank
拨禾轮高度调节曲柄
15.
double crankless press
两点式无曲柄压力机
16.
crank angle signal sender
曲柄转角信号发送器
17.
recirculating ball-lever and peg steering gear
循环球-曲柄销式转向器
18.
open-type double action crank press
开式双动曲柄压力机