1.
The high-frequency pulse waveform of WEDM pulse generator was analyzed. Basic condition method is presented the results is well.
分析了电火花线切割机脉冲电源的高频脉冲波形，提出了有效的控制方法，获得了良好的综合效果。
2.
Research on WEDM Pulse Power Supply Based on ISA Bus;
基于ISA的电火花线切割脉冲电源研究
3.
Research on Improving the Main Control Circuit Based on the Pulse Power Supply of Electric Spark Line Cutting Machine
基于电火花线切割机床脉冲电源的主控电路改进研究
4.
Research on Bidrectional Narrow Pulse Generator of Non-Resistance for WEDM;
往复走丝线切割窄脉宽无阻脉冲电源的研究
5.
Research on Micro Energy and Controllable Pulse Power Supply for MWEDM;
微能可控微细电火花线切割脉冲电源的研究
6.
Study on Energy-Saving Pulse Generator for WEDM;
电火花线切割加工节能脉冲电源的研究
7.
DESIGN FOR INTERRUPT ACCESS OF DEVICE DRIVER OF NON-RESISTANCE PULSE GENERATOR FOR WIRE ELECTRICAL DISCHARGE MACHINING BASED ON WDM;
基于WDM的电火花线切割无阻脉冲电源中断驱动程序设计
8.
Research of Digital AC Voltage Controller Technology for LS-WEDM;
低速走丝线切割脉冲电源数字化交流调压技术研究
9.
The Study of Processing the Waste Water Emulsion of Linear Incision by the Method of Pulse Electroflocculation and Chemical Coagulation;
脉冲电絮凝法和化学混凝法处理线切割乳化液废水的研究
10.
The Study and Design on Pulse Standard Signal Generator for LSWEDM
慢走丝线切割机床脉冲基准信号发生器的研究与设计
11.
The Study on Pulse Generator for LSWEDM
低速走丝线切割机床脉冲基准信号发生器的研究
12.
NC EDM wire-cut machine
电火花数控线切割机床
13.
NC wirecut EDM machine
数控电火花线切割机床
14.
taper wire-cut EDM machine
锥度电火花线切割机床
15.
super CNC wirecutting machine
电火花数控线切割机
16.
The Design of Power Source of Linear Motor Based on Bilateral Pulse Variable Frequency Control;
双向脉冲变频控制直线电机电源的研究与设计
17.
Study on the Control Technology of Isopulse with WEDM;
线切割加工中等能量脉冲控制技术的研究
18.
Discuss on Multi-Times Cutting Technology of Move Back and Forth Run-Wire WEDM
往复走丝电火花线切割机床多次切割技术探讨