1.
This paper presents an improved design of the mixing-pouring truck introd uced from abroad.
介绍了对引进加气混凝土搅拌浇注车的改进设计。
2.
Optimization of feed system and design of injection mould for automotive engine cover
汽车发动机罩盖浇注系统优化与注射模设计
3.
Anti-warpage Gate Design Analysis for Injection-molded PBT Long-armed Lamp Holders
车用PBT长臂灯架防翘曲注射浇口设计分析
4.
Runner System Optimization of Transit Automobile Bumper Based on CAE
基于CAE的全顺汽车保险杠浇注系统优化研究
5.
Analysis on Entrapped Slag Defect of Cast Steel Wheel Poured Continuously by Bottom Pouring Ladle
用底注包连续浇注铸钢车轮产生夹渣缺陷的分析
6.
The vehicle stands on the finished concreted tunnel Base with the direction of travel corresponding to the direction of lining.
车辆位于浇注好的隧道基底上,移动方向与衬砌方向一致。
7.
Application of Multi-gates Sequence Control Technology in the Injection Molding of Auto Lamp Lens
多浇口顺序控制技术在车灯面罩注射成型中的应用
8.
Analysis and Control of Weld Marks of Auto Lamp Reflector Based on Valve-injection
基于阀式浇注系统的车灯反射体熔接痕的分析与控制
9.
Quality Evaluation of JZ35 Axletree Billets Produced by Different Casting Process
采用不同浇注工艺生产JZ35车轴用钢坯的质量评价
10.
Pour a solid foundation of cement
浇注坚实的水泥地基
11.
concreting boom
浇注混凝土起重机臂
12.
connecting rod babbitting jig
连杆巴氏合金浇注器
13.
connecting rod bearing pouring
连杆轴承巴氏合金浇注
14.
A mold for the setting of concrete.
模板浇注混凝土的模板
15.
Cast Process of Winding in Epoxy Resin Cast Dry-Type Transformer
环氧树脂浇注干式变压器的绕组浇注工艺
16.
cart with a tank and sprinkler for sprinkling roads.
盛水的用来浇路面的车。
17.
Technology of Inclined Cast Avoid Appeared the Defects of Misrun in Oven Door Casting
倾斜浇注防止焦炉炉门铸件产生浇不足缺陷
18.
The Secondary Development of Autocad for Feed System of Injection Mold;
注塑模浇注系统的AutoCAD二次开发