1.
Install pinion front bearing, if necessary.
如需要，安装小齿轮前轴承。
2.
Analysis and Treatment of Excessive Vibration of Exciter Front Bearing for 300 MW Unit
300MW机组励磁机前轴承振动大的原因分析及处理
3.
Front Stub Axle To Hub Bearing Nut
前螺桩轴至轮毂轴承螺帽
4.
Measuring diameter of fore and aft stern tube bearing and bushes.
艉轴管前、轴承与衬套直径测量。
5.
Shaft Assembly (Male, female, washer, grease….
轴组件（轴，轴套，轴承，油脂。。。）
6.
Replace the front strut upper mount and bearing
更换前支柱上固定座与轴承
7.
Application of AMB Part One:Development and Prospects of Active Magnetic Bearing in Aeroengine
电磁轴承及其应用 第一部分 电磁轴承的发展及其应用前景
8.
Bearing Clearance (#1 Journal)
轴承间隙（#1轴颈）
9.
plain bearing housing with bearings
装有轴承的普通轴承座
10.
housing bearing plain without bearings
未装轴承的普通轴承座
11.
radial Bearing and thrust Bearing
横力轴承与推力轴承
12.
cageless bearing
无保持架轴承,开口轴承
13.
upper center crankshaft bearing
曲轴主轴承上中轴瓦
14.
"On many engines, the connection-rod and main bearings (crankshaft bearings) can be checked for wear with an oil-leak detector before the engine is torn down."
许多发动机在拆卸之前,可以用漏油检测装置检查连杆和主轴承(曲轴轴承)的磨损情况。
15.
This paper analyzes the reasons for the burning of the front radial bearing of the generator turbine Y1701, presents the solutions for modification and the final effects.
针对Y?701发电汽轮机前径向轴承烧瓦故障，分析前径向轴承烧瓦原因，介绍改进措施及效果。
16.
Before performing this procedure, the worm bearing preload adjustment must be performe
进行本程序之前，必须调节螺杆轴承的预应力。
17.
Permanently sealed and lubricated ball bearings front and rear.
前后端盖装有永久密封和自润滑的滚珠轴承。
18.
Advanced Angle Calculating Method for Winding Currents in Bearingless Switched Reluctance Motor
无轴承开关磁阻电机绕组电流超前角计算方法