1.
feed regulator thumb screw
进料调节器指拧螺丝
2.
Tighten the pressure regulator.
请拧紧压脚调节螺丝。
3.
Loosen setscrew 4.
拧松线张力杆固定螺丝4进行调整。
4.
Neck plate can be adjusted by using the thumbscrews.
用指拧螺旋调节颈部保护片。
5.
Move the feed dog up or down to perform adjustment, then securely tighten the screw.
上下移动送布牙调节高度，然后拧紧紧固螺丝。
6.
Loosen the adjustment screw, and adjust the length of the link rod.
请拧松调整螺丝，拔出或插入连接杆进行调整。
7.
Unscrew body halves using open end or adjustable wrench on flats provided.
采用预备好的平头上开口或可调节扳手拧下一半阀体上的螺丝。
8.
Remove the throat plate, loosen hook screw 6 and adjust the hook.
调整旋梭时，请卸下针板，拧松旋梭固定螺丝6，然后进行调整。
9.
Using a screwdriver to adjust the thermostat pointer, set the thermostat( s) to the desired water temperature.
使用螺丝刀调节温控器上的指示器，设置所需要的水温。
10.
Install all fender screws finger-tight.
安装时用手指拧紧所有的挡泥板螺丝。
11.
Tighten adjustment screw to 3 N·m (30 in-lbs) torque.
拧紧调整螺丝到3 N·m (30 in-lbs)扭力。
12.
Gunnplexer tuning screw travels IN to LOWER the frequency.
耿儿的调谐螺丝往里拧频率降低。
13.
Replace clean dustfilter and tighten screws
换上清洁的滤尘器, 拧紧螺丝
14.
Adjust the nose of the ram to align the pointer with the SET mark on the scale of the tester and tighten the hex nut.
调整压头鼻，利用测试器标尺上设定的标记对齐指针，拧紧六角螺帽。
15.
The wood is so dry the screws don't bite.
这根木头太干了,所以螺丝钉都拧不进去。
16.
Set the thermostats to the desired water temperature using a screw driver to move the thermostat pointer
使用螺丝刀移动温度控制器的指示器将温度调节到自己所需要的温度
17.
Maximize the stitch length, and turn the handwheel until walking foot 1 reaches its front end position. Now, loosen screw 2 in the center shaft bell crank.
把缝迹调到最大，转动飞轮，在外压脚1前进到最前的位置拧松中轴轮紧固螺丝2。
18.
He took out the screws, got rid of the hardware,
他拧下螺丝，卸掉零件，