1.
vertical motor rotator die casting machine
![点击朗读](/dictall/images/read.gif)
立式电机转子压铸机
2.
Optimize Study of Pressure Die-casting Technology for Producing Motor Rotator
![点击朗读](/dictall/images/read.gif)
电机转子压力铸造工艺及参数优化研究
3.
Curved plates: Electros or stereos shaped for use on rotary printing machines.
![点击朗读](/dictall/images/read.gif)
弧形板:轮转机手的电铸版或铅铸版。
4.
Centrifugal Casting of Cylinder Liner of Air Compressor Used for Mine Electric Locomotive
![点击朗读](/dictall/images/read.gif)
矿用电力机车空压机缸套的离心铸造
5.
Discussion on rotor yoke lamination factor of hydraulic generator
![点击朗读](/dictall/images/read.gif)
试论水轮发电机组转子磁轭“叠压系数”
6.
Modern Stamping Technology into the Motor Lamination
![点击朗读](/dictall/images/read.gif)
电机定转子铁芯零件的现代冲压技术
7.
"The motor rotor shall be of die cast aluminum, fabricated copper or their respective alloys."
电机定子应该采用压铸铝,装配铜或其各自的合金等材质制造。
8.
Research on Technique of Rotor Magnetism Extinguishing and Over-voltage Protection for Large Generator;
大型发电机转子灭磁及过电压保护技术的研究
9.
The Power Capacity Experimental Study of Piezoelectric Vibrator on Rotary Mechanism;
![点击朗读](/dictall/images/read.gif)
压电振子在旋转机构上的发电能力的试验研究
10.
Influence of Rotor Windings Inter-turn Short Circuit Fault on Electric Machine Shaft Voltage
转子绕组匝间短路对电机轴电压的影响
11.
direct pressure hot-chamber machine
![点击朗读](/dictall/images/read.gif)
直接加压的热室压铸机
12.
direct air injection die-casting machine
![点击朗读](/dictall/images/read.gif)
直接气压式热室压铸机
13.
Mac Intosh cell
![点击朗读](/dictall/images/read.gif)
转子型压气式浮选机
14.
Research of Ultrasonic Inspection Technique of Steam Turbine on Blade Root in Nuclear Power Plant
核电厂汽轮机低压转子叶片叶根超声检测技术
15.
Improvement of rotor demagnetization and overvoltage protection
![点击朗读](/dictall/images/read.gif)
发电机转子灭磁与过压保护装置的改进
16.
Rated-locking force is the main die-casting technology parameter of die-casting machine.
![点击朗读](/dictall/images/read.gif)
合型力是压铸机主要的压铸工艺参数。
17.
Design of Rotor Position Detecting Circuit of PMSM Based on Resolver
![点击朗读](/dictall/images/read.gif)
基于旋转变压器的永磁同步电机转子位置检测电路设计
18.
Each rotor core is visually inspected for complete filling of the die-cast end rings and fan blades.
每个转子芯都经过人工检查是否完整配置压铸轴承挡圈和风机叶片。