1.
The Seismic Behavior Analysis of Steel Frame Beam-to-Column Web Connection with Bolted-Splicing
钢框架梁柱弱轴螺栓拼接节点的抗震性能分析
2.
It's a important join component of hydrogenerator main shaft fasten joint bolt.
水轮发电机主轴联轴螺栓是水轮发电机重要的联接部件。
3.
hydrauliccone-bolt coupling
液力锥形螺栓联轴器
4.
Remove nuts, U-bolts and spring bracket from axle.
由车轴拆下螺帽，U型螺栓和弹簧支架。
5.
Bolt( screw, nut, stud, spring washer, pin, ball bearing, roller bearing) is the most commonly used machine part.
螺栓（钉、帽、头螺栓、簧垫圈、、珠轴承、柱轴承）最常用的机械零件。
6.
Lock rings at the end of shaft with bolt
GB/T892-1986螺栓紧固轴端挡圈
7.
Bushing Retainer To Axle Attaching Bolts
衬套扣环与车轴接合螺栓
8.
Remove vibration damper bolt and washer from end of crankshaft.
从曲轴端拆下减震器螺栓和垫圈。
9.
Tie Rod End Adjusting Sleeve Nut
转向拉杆端调整轴筒螺栓
10.
Experimental Study on Fastening Bolt Axial Force of WSGG Anchor Basted on CFRP Sheet
CFRP波形齿锚具紧固螺栓轴力的试验
11.
Contact analysis of MW wind turbine hub and bearing bolt connection
风力机轮毂和轴承螺栓联接接触分析
12.
377 bolt (screw, nut, stud, spring washer, pin, ball bearing, roller bearing) is the most commonly used machine part.
螺栓（螺钉、螺帽、双头螺栓、弹簧垫圈、销、滚珠轴承、滚柱轴承）是最常用的机械零件。
13.
Remove the upper suspension arm nut and bolt at the axle bracket.
从车轴支架上拆去上端悬吊臂螺帽和螺栓。
14.
Remove the lower suspension arm nut and bolt from the axle bracket.
从车轴支架上拆去下端悬吊臂螺帽和螺栓。
15.
Remove the universal joint strap bolts at the pinion shaft yoke.
在小齿轮轴轴轭处拆卸万向节扣夹螺栓。
16.
Install the straps and bolts to hold the propeller shaft to the yoke.
安装扣夹和螺栓，将传动轴固定到轴轭上。
17.
Inspect crankshaft, flexplate/flywheel and bolts for damagTighten to correct torque
检查曲轴、活动板/飞轮和螺栓是否松动。拧紧螺栓以校正扭力。
18.
Compared with conventional coupling bolts, the hydraulic radial-fit bolts can effectively prevent unsmooth stagnation.
与传统联轴器螺栓相比，液压螺栓能有效地防止卡涩和咬死。