1.
Hydraulic support back link:ANSYS bases strength analysis and structure optimization
基于ANSYS的液压支架后连杆强度分析及结构优化
2.
A pole connecting the rear axle of a vehicle with the front.
连接杆连接车辆前后轴的杆
3.
Inspection alignment of stock, rudder blade and pintle.
舵杆、舵叶、舵销连接后中心线检查。
4.
Suspension: 4-wheel independent with rear multi-link
后多连杆式4轮独立悬吊
5.
Development and Simulation Analysis of Two-link Rear Suspension Template;
双连杆后悬架模板的开发及仿真分析
6.
A rod or lever transmitting motion in a machine.
连杆机器中传递运动的连杆或杠杆
7.
"After the piston-and-connecting-rod assemblies have been removed from the engine and the pistons and rods separated, the rings should be removed from the piston.."
先将活塞及连杆组件从发动机上拆下再把活塞与连杆分开之后,即可将活塞环从活塞上取下。
8.
Disconnect stabilizer bar links at the axle.
断开车轴上稳定杆连杆。
9.
Variation laws of connecting rod curves for five bar and similar four bar mechanism
类四杆五杆机构连杆曲线的变化规律
10.
Install connecting rod bolt protectors on rod bolts.
在连杆螺栓上安装连杆螺栓保护件。
11.
The rod-bearing cap attaches the connecting rod to the crankpin.
连杆轴瓦盖将连杆安装到曲轴销上。
12.
The Analysis of the Points Paths on Link of Plane Five-bar Linkages;
平面五连杆机构连杆上点的轨迹分析
13.
A beam that connects the piston rod to the connecting rod of a reciprocating engine.
十字头连接活塞杆和往复式发动机连杆的横杆
14.
Keep flame away from rod or wire as it is fed into the joint. Move flame back and forth as alloy is drawn into joint.
当焊杆或焊线进入连接处时要将火焰从其上面移开。当合金流进连接处时,要前后移动火焰。
15.
Connect the temperature control cable core end to the temperature control lever on the back of the heater-A/C control.
在取暖器-空调控制后部上连接温度控制电缆核末端至温度控制连杆。
16.
Put these two-elevator push rod out from the side back of the fuselage, then fix it with plastic U collet.
将此两根升降舵连杆钢丝从机身后部侧面开口中伸出后再拧上塑料u形夹头。
17.
Because the back roller is used to apply the warp tension, it and its associated system of levers must be robust.
由于后梁是用来施加经纱张力的,后梁及其辅助系统的连杆必须具有足够的强度。
18.
back-side-crank pumping unit
单拐多连杆抽油设备