1.
Ultimate load designs according to the yield-line or strip methods do not guarantee safety against cracking or excessive deformation.
接屈服线法或条带法的极限荷载设计不能完全保证抗裂或防止过度变形。
2.
the ultimate bearing capacity of anchorage zone attains 3.07 times as much as its designed load.
索梁锚固区的极限承载力为设计荷载的3.07倍,有一定的安全储备。
3.
load-limit programmer
负载极限程序设计器
4.
Limit Load Calculation and Risk Assessment of Buried Pipe;
埋地管道的极限载荷计算与风险评价
5.
Ultimate Equivalent Load Balance Method for Plastic Design of PC Continuous Beams (Slabs) with Unbonded Tendons
无粘结PC连续梁（板）塑性设计的极限等效荷载平衡法
6.
Strength and Limit Load Analysis of Concrete Arch Dams
混凝土拱坝的强度计算与极限荷载分析
7.
Solution of Ultimate Load for Slope and Foundation with Finite Element Lower Bound Limit Analysis Method
边坡与地基极限荷载的下限有限元解
8.
The Calculation of the Load-Carrying Ability of Cylindrical Shells Under Uniform External Pressure by Using Ultimate Load Equation
极限载荷方程在受外压圆柱壳承载能力计算中的应用
9.
Calculating Ultimately Bearing Capacity of Vertically Loading Single Pile;
竖向荷载作用下单桩极限承载力计算方法的研究
10.
Estimation of Ultimate Resistant Capacity of Non-Symmetric Planar Steel Frame Structures under Horizontal Load
平面非对称钢框架结构在水平荷载下的极限承载力估计
11.
Researches on Critical Edge Load,Critical Load and Ultimate Load of Soil Mass
地基的临塑、界限和极限荷载的探讨
12.
Research and Design of Overload Limiter without Load Sensor
无载荷传感器式起重限量器的研究与设计
13.
DOMINANT FAILURE MODES OF A TRANSMISSION TOWER AND ITS ULTIMATE CAPACITY UNDER WIND LOAD
风荷载下输电铁塔的失效模式及其极限荷载
14.
Analysis of Estimating Ultimate Loading and Static Test of Screw Pile Under Inclined Loading
承压螺旋桩斜向荷载试验与极限荷载判定分析
15.
The Caculation of the Structure Loads, Finite Element Analysis and Optimization of the Front Frame of CLG856 Wheel Loader;
CLG856型轮式装载机前车架结构载荷计算、有限元分析与优化设计
16.
Design and simulation of load limit sensing control system for engine-variable pump system
发动机-变量泵极限负荷控制系统的设计与仿真
17.
Research on Plastic Limit Load of Local Thinning Elbow for Engineering Calculation Method;
含局部减薄弯管塑性极限载荷工程计算方法研究
18.
Research on the method for calculating allowable external pipe load applied to brazed aluminum heat exchanger based on limit analyse
基于极限分析的铝板翅式换热器封头许用接管载荷计算方法研究