1.
Many repeated excursions into the yield range will eventually bring destruction to steel.
在屈服范围内的多次重复振动，最终将会把钢结构物毁坏。
2.
Tower crane slewing compound vibration and dynamic load calculation
塔式起重机回转复合振动及动载荷计算
3.
Rejection of disturbances in linear vibration table with robust adaptive repetitive control
抑制线振动台扰动的鲁棒自适应重复控制
4.
Robust adaptive repetitive learning control for low-frequency linear vibration table system
低频线振动台系统的鲁棒自适应重复学习控制
5.
For a vibrating plate, the vibrating velocity is reconstructed by iterative regularization method.
以振动平板为例，分别对简单振速分布和复杂振速分布采用迭代正则化方法进行了重构。
6.
Research on Active Control of Vibration for Complex Vibration Isolation System;
复杂隔振系统振动主动控制策略研究
7.
Vibration of waterpower set is complex,which includes me chanical vibration,hydaulic vibration,electric vibration and so on.
水力机组的振动复杂 ,有机械振动、水力振动、电气振动等。
8.
Experiment Study on YTONG Panel Joint Intensity and Iterative Load Action and YTONG Wall Simulate Earthquake Shaking Talbe;
伊通墙板节点强度、重复荷载作用及墙体模拟地震振动台试验研究
9.
Extracting Progress of Pueraria lobata by Orthogonal Method with Duplicate Test
正交设计-重复实验法优选葛根的超微振动提取工艺
10.
Method and Simulation Studies of Hydraulic Servo Vibration Platform Based on Repetitive and PID Control
液压伺服振动台的基于重复控制补偿PID控制方法
11.
Sound is caused by vibrations. A vibration is a back and forth movement.
声音是由振动引起的。振动就是往复运动。
12.
Flexural vibration of a compound bar piezoelectric transducer
复合棒压电纵向振动换能器中的弯曲振动
13.
Parametric oscillation model of the load swing of bridge crane
桥式起重机吊重摆动的参变振动模型
14.
Obstruction or vibration in the movement of roving traverse.
粗纱导纱器的往复运动不灵活或振动。
15.
Research on Power Flow Transmission and Experiment of Complex Vibration Isolation System;
复杂隔振系统振动传递特性及实验研究
16.
The Study on Vibration and Vibration Control of the Pipeline of Reciprocating Compressor;
往复式压缩机出口管系振动及减振的研究
17.
Analysis of Reciprocating Pump Vibration and Noise Mechanism and Reduction Measures
往复泵振动和噪声机理分析及减振降噪措施
18.
This paper focused on such problems as mixing models of sources of rotation machines (including vibratory and acoustical sources) and their waveform restoral.
重点讨论了旋转机械源（包括振动激励源与噪声源）混合模式及源波形恢复问题。