1.
There are many shortcut methods in moment distribution.
在弯矩分配中有很多的简化法。
2.
Barycentric interpolation collocation method for thin rectangular plates bending problems
重心插值配点法分析矩形薄板弯曲问题
3.
Experimental Study and Analysis of Prestressed Subassemblage Concrete Frame on Moment Modification;
预压装配式预应力混凝土框架弯矩调幅实验研究与理论分析
4.
Research on Flexural Behavior of Reactive Powder Concrete Rectangular Beam with Steel Bars;
活性粉末混凝土矩形截面配筋梁抗弯性能研究
5.
RESEARCH ON NON-LINEAR MOMENT-CURVATURE OF UNBONDED POST-TENSIONED PRECAST CONCRETE BEAMS
无粘结预应力装配梁非线性弯矩曲率的研究
6.
The Analysis of Moment Magnifier for Reinforced Concrete Arch Bridge;
钢筋混凝土拱桥弯矩增大系数的分析
7.
On Bending of Functionally Graded Rectangular Plates with DQ Method
功能梯度矩形板弯曲分析的DQ方法
8.
Boundary integration method of bending of thick rectangular plate with the corner paint hang in the air
角点悬空弯曲厚矩形板的边界积分法
9.
Analysis of Moment-curvature Hysteresis Behavior of Composite Beams
组合梁截面弯矩—曲率滞回性能分析
10.
Research on the Torque Distribution Characteristics of Dual-Turbine Torque Converter
双涡轮液力变矩器转矩分配特性研究
11.
Interface Slip and Full Process Analysis of Double Steel-Concrete Composite Beam under Negative Bending;
钢－混凝土双面结合梁负弯矩区滑移及受弯全过程分析
12.
Discussion about"Analysis of Correlation Curves between the Axial Force of Eccentrically Pressed Member with Rectangular Cross Section and the Bending Force Moment;
关于“矩形截面偏心受压构件轴力——弯矩相关曲线分析”的探讨
13.
Virtual Work Method of Rectangular Two-Way Slab Considering Resistance Moment of Inclined Yield Line
考虑斜向塑性铰线抵抗弯矩的矩形双向板虚功分析法
14.
Effects of Reinforcing Bar Amount on Bending-resistance Bearing Capacity of Single-side Reinforced Rectangular Beam
纵向钢筋配筋量对单筋矩形截面梁截面抗弯承载力的影响
15.
Analysis of Connections of Slab to Edge Column under Shear and Unbalanced Moment
混凝土板柱边节点在剪力和弯矩作用下的分析
16.
APPLICATION OF TRANSFER MATRIX METHOD FOR ANALYZING TORSION-BENDING-COUPLED VIBRATION OF SHIP HULL
迁移矩阵法在船体弯扭耦合振动分析中的应用
17.
Study and Calculations of Capsizing Moment of Circumfluence on Ships in Curving Channels
弯道中环流对船舶产生的倾覆力矩计算分析
18.
Out-of-Plane Bending Moment Analysis of the Plastic Limit for the Welded Piping Tee Containing Bottom Thinning Defects
底部减薄焊制三通的塑性极限面外弯矩分析