1.
capstan tachogenerator signal
主导轴转速传感信号
2.
The carriage is supported on guide shafts.
托架支承在导轴上。
3.
capstan PWM generator
主导轴脉宽调制发生器
4.
Lightly lubricate pilot bearing with Mopar® high temperature bearing grease.
用Mopar®高温轴承黄油轻轻地润滑引导轴承。
5.
Welds repair of the bush of water flowing diversion bearing of the hydro-generator unit
水轮发电机组水导轴承轴瓦的焊接修复
6.
The Determination of the Critical Technical Supply Pressure of the Rubber Guide Bearing of the Axial Pump
轴流泵橡胶导轴承技术供水临界压力的确定
7.
The slide bearing assembled in middle segment is separated from sewage by inside pipe.
中间节设有由内导管将污水隔离的滑动导轴承。
8.
As lubricated with outside clean water, bearings are of long life.
导轴承由外接清洁水润滑，使用寿命长。
9.
upper guide-metal
上导轴瓦乌金 -水轮发电机
10.
capsizing moment capstan
绞盘起锚绞盘录音主动轮主导轴
11.
Dynamic Coefficients of Tilting Pad Guide Bea-rings of Hydraulic Turbine Sets, Power Engineering
水电机组可倾瓦导轴承动力特性系数
12.
Pilot bearing in crankshaft. The pilot bearing in the crankshaft is usually either a Bushing or a Ball bearing.
曲轴上的导向轴承:曲轴上的导向轴承一般或者是轴瓦,或者是球轴承。
13.
New inference method of the optic axial angle and the ray axial angle of the negative biaxial crystal
负双轴晶体光轴角和光线轴角推导的新方法
14.
stabilizer link shaft
履带牵引车导向机构轴
15.
The influence of the journal misalignment in bearing bore resulted from crankshaft deformation when it acted by load should be considered in the lubrication analysis of crankshaft bearing.
曲轴轴承的润滑分析应该考虑曲轴受载变形导致轴颈在轴承孔中倾斜的影响；
16.
3D-PIV Measurements in Clearance between the Impeller and the Diffuser of an Axial Flow Pump;
轴流泵叶轮与导叶轴向间隙内流场的3D-PIV测量
17.
Effects of non-axisymmetric IGV wakes on a low speed axial compressor
非轴对称导叶尾迹对低速轴流压气机的影响
18.
THE CORRECTION FOR THE BASIC AXIS ERROR OF THE INERTIAL TERMINAL GUIDANCE ON THE ANTIRADAR MISSILE
反雷达导弹惯性末制导基准轴误差的修正