1.
The puddle section for heavy duty batteries must be at least the thickness of the base of the poststrap.
重型汽车蓄电池极柱焊接部位至少要等于极柱底座的厚度。
2.
After installation, the position of galvanization coating destroyed due to welding, cutting and scratch etc. shall be carried out anti-corrosive coating by installer on site.
对安装后的焊接部位，裁切口，碰损擦伤等锌层遭到损伤的部位，要求现场施工人员进行防腐涂装。
3.
Residual stress analysis of repair welding at different zone of Q345R welded joint based on finite element simulation
Q345R钢焊接接头不同部位补焊残余应力的有限元分析
4.
Collocated with 2 meters long push gun and pinch welder, and can go deeply.
配置2米长手持点焊枪和焊钳，能深入焊件内部及特殊部位进行焊接。
5.
All position pipe welding device for remote welding
用于遥控焊接的管道全位置焊接装置
6.
The union of two metal parts by welding.
焊接把两个金属部件焊接为一个整体
7.
Application of all-position activate welding in pipeline
A-TIG焊在核电管道全位置焊接中的应用
8.
Research of locating bonding points automatically in chip bonding
芯片焊接中焊点自动定位技术的研究
9.
Application of the twin-wire welding for robot central slot welding
机器人双丝焊在中部槽焊接上的应用
10.
Through the algorithms, robot can weld the workpiece on downhand welding position, which is easer to ensure the good welding quality.
通过机器人系统的运动学和平焊位置算法,可以实现焊缝在平焊位置焊接,从而保证了焊接质量.
11.
Automatic submerged arc welding is the method for medium/ thick plate welding, but it mainly to be used in flat welding and fillet welding.
埋弧自动焊是焊接中厚板常用的焊接方法,但常规用在平、角焊位置的焊接。
12.
Recognition and positioning of start welding position for arc welding robot
弧焊机器人起始焊接位置图像识别与定位
13.
On Influence of Welded Joint on Fracture Parameter with Crack in Different Location
裂纹位置对焊接接头断裂参量的影响
14.
3. Apply flux to outside of tube and inside of solder cup. Surfaces to be joined must be completely covered. Use flux sparingly.
3. 在管道的外面和焊接罩的内部涂上焊剂,焊剂必须完全覆盖焊接表面。请有节制地使用焊剂。
15.
apply flux to outside of tube and inside of solder cup. Surfaces to be joined must be completely covered. Use flux sparingly.
在管道的外面和焊接罩的内部涂上焊剂,焊剂必须完全覆盖焊接表面。请有节制地使用焊剂。
16.
horizontal rolled position
转动横向焊位置(指管子环形接头横向焊
17.
horizontal fixed position
固定横向焊位置(指管子环形接头横向焊
18.
Special welding machine and welding process for all position automatic pipeline welding
管道全位置自动焊机的专用电源及焊接工艺