1.
The piston is essentially a cylindrical plug that moves up and down in the engine cylinder.
实质上活塞是一个在气缸中上下移动的圆筒状的塞子。
2.
The piston end of the rod is attached to the piston by the piston pin, or wrist pin.
连杆的活塞端用活塞销或销轴安装在活塞上。
3.
Installing Balls in Rack Piston
在齿条活塞上安装球
4.
Remove tool from rack piston.
从齿条活塞上拆下工具。
5.
ID mark on face of upper and intermediate piston rings must point toward piston crown.
上和中活塞环面上ID标记必须指向活塞头。
6.
"After the piston-and-connecting-rod assemblies have been removed from the engine and the pistons and rods separated, the rings should be removed from the piston.."
先将活塞及连杆组件从发动机上拆下再把活塞与连杆分开之后,即可将活塞环从活塞上取下。
7.
A valve mechanism in brass instruments for altering the pitch.
活塞阀键一种铜管乐器上调节音量的活塞阀键
8.
"Thus, piston rings must be used to provide the necessary seal. The rings are installed in grooves in the piston. Actually, there are two types of rings, compression rings and oil-control rings."
所以活塞环就用来提供必要的密封。活塞环装在活塞的凹槽中。事实上有两种活塞环,气环和油环。
9.
PISTON DISPLACEMENTPiston displacement isthe volume that the piston displaces as it moves from BDCto TDC.
活塞排量:活塞排量是当活塞从下止点运行到上止点时,活塞排出气体的体积。
10.
The piston slides noiselessly up and down.
这个活塞上下活动,没有响声。
11.
"The air volume with the piston at TDC is called the clearance volume, since it is the clearance that remains above the piston at TDC."
活塞在上止点时的气体体积称为余隙体积,是活塞在上止点时,活塞上部所剩余的气体容积。
12.
a force applied by a piston to a small area is transmitted through water to another piston having a large area.
作用在小面积活塞上的力通过水转化成作用在大面积活塞上的力。
13.
"After the piston has passed through BDC and starts up again, it passes Both ports, thus sealing them off."
在活塞通过下止点,并开始上升时,活塞经过进气口和排气口,将其堵
14.
It is equipped with piston rings to provide a good seal between the cylinder wall and piston.
上面装有活塞环,从而使活塞和气缸壁之间具有良好的密封性。
15.
The piston moves up and down in the piston chamber primarily in response to changes in intakemanifold vacuum.
活塞主要因进气歧管真空度的变化而在活塞腔内上下移动。
16.
The push rod was screwed into a miniature piston head.
这根推杆拧紧在一个微型的活塞头上。
17.
) The inside surface of the ring fits in the groove on the piston.
)些环的内表面和活塞上的凹槽相配合。
18.
Remove piston and connecting rods from crankshaft journals.
从曲轴颈上拆下活塞和连杆。