1.
The detector manufacturer states that a normal bearing will leak between 20 and 150 drops of oil a minute.
这种装置的制造厂商指出,标准轴承每分钟应漏油20～150滴。
2.
Undersize crankshaft main bearing journals.
尺寸小于标准的凸轮轴主轴承轴颈。
3.
Align the installation reference marks on the propeller shaft and yoke and install the propeller shaft.
对准传动轴和轭上安装参考标记，安装传递轴。
4.
Manufactured carbon steel OSHA shaft and belt guarding are standard.
标准的OSHA碳钢轴和皮带防护罩。
5.
The Research of Coax Access Network Base on MoCA;
基于MoCA标准的同轴接入网络研究
6.
Research on the Tunnel Technical Standard under 30t Axis Load
30t轴重条件下隧道技术标准研究
7.
Development of Library of Tapered Roller Bearings Based on PLIB Standard
基于PLIB标准的圆锥滚子轴承库开发
8.
Align mark on the rear link yoke and universal joint to the mark on the transfer case yoke.
将后连接轴轭和万向节上的标志与传动箱轴轭上的标志对准。
9.
Align previously made marks on yoke and propeller shaft and install propeller shaft.
将定位轭架上的预制标记对准传动轴并安装传动轴。
10.
OSHA shaft and belt guarding is standard for increased safety.
标准的OSHA轴和传动皮带，提高运行安全性。
11.
Selection of a bearing from the suggested standard range would give d=28cm.
根据建议的标准系列来选择轴承应得d＝28cm。
12.
The Recension of "Propulsion Shaft Alignment Of Ship" National Standard;
《船舶推进轴系校中》国家标准修订的探讨
13.
The research on the knowledge-based expert system of non-standard rolling bearing;
基于知识的非标准滚动轴承专家系统的研究
14.
The Standard Form of a Pair Potential Model for Biaxial Nematic Liquid Crystal
一种双轴向列相液晶两体势模型的标准化形式
15.
The Disquisition about the Establishing for the Library of Bearing Standard Parts Based on Pro/E
基于Pro/E轴承标准件库参数化技术的应用研究
16.
Standard Parallels Computation for Normal Conformal Secant Conic Projection Based on Graded-Traversal Approach
一种正轴等角割圆锥投影标准纬线的求算方法
17.
Development of Three-dimensional Standard Parts Library of Rolling Bearing Based on SolidWorks
基于SolidWorks的滚动轴承三维标准件库的开发
18.
Zhenjiang zetai Bearing Plant especially produces"0" grade deep-groove ball bearing and various low-noise, non-standard and specially required bearings.
镇江泽泰轴承有限公司专业生产“0”类深沟球轴承及各种低噪音，非标准及特殊要求的轴承。