1.
The Design of Double Video Showand Princip Axis Alignment for Polarization Maintaining Fiber Splicer
保偏熔接机双路显示及主轴对准实现方法
2.
Align the installation reference marks on the propeller shaft and yoke and install the propeller shaft.
对准传动轴和轭上安装参考标记，安装传递轴。
3.
Research on Position Alignment Method of a Three-axis Simulator
三轴转台三轴交汇中心位置对准方法的研究
4.
Research of Virtual Absolute Rotary Encoder Using M-code;
准绝对式M码光电轴角编码器的研究
5.
Research on Key Technology of AFAT in Deepwater
深水管道轴向对准工具关键技术研究
6.
Align previously made marks on yoke and propeller shaft and install propeller shaft.
将定位轭架上的预制标记对准传动轴并安装传动轴。
7.
Align mark on the rear link yoke and universal joint to the mark on the transfer case yoke.
将后连接轴轭和万向节上的标志与传动箱轴轭上的标志对准。
8.
Research of Control System about Axial Force Tool for Deep-Water Pipeline
深水管道轴向对准工具控制系统的研究
9.
Discussion on Monitoring Accuracy of Axial Force of Concrete Bracing of Metro Foundation Pit Works
对地铁基坑混凝土支撑轴力监测精准性的探讨
10.
Initial alignment of SINS based on the continuous rotation of the azimuth axis
捷联惯导连续旋转方位轴式初始对准研究
11.
Undersize crankshaft main bearing journals.
尺寸小于标准的凸轮轴主轴承轴颈。
12.
Align mark on front universal joint, or CV joint, to the mark on the axle pinion yoke, or flange.
将前万向节或CV万向节上的标志与车轴小齿轮轴轭或凸缘上的标志对准。
13.
The N9 cooling fan mounts directly to the crankshaft via a top and bottom self-aligning split collet system.
该套N9号冷却风扇直接透过曲轴上下自我分裂对准夹头系统.
14.
The pivot and race surfaces were true surface of revolution and were correctly centred when no load was applied.
轴枢和套圈的表面是准确的旋转表面，并在未施加载荷正确对中。
15.
An Investigation of Braking Force Distribution Requirements for Passenger Cars in Braking Standards
对制动标准中关于轿车轴间制动力分配要求的探讨
16.
Perfect elastoplastic solution of axisymmetric circular openings in rock mass based on Levy-Mises constitutive relation and D-P yield criterion
基于Levy-Mises本构关系及D-P屈服准则的轴对称圆巷理想弹塑性解
17.
wheel cylinder adjusting pinion shaft
轴闸储气筒调准小齿轮轴
18.
electrical boresighting adjustment
光轴与电轴一致性的校准