1.
cylinder wall surface temperature transducer
汽缸壁表面温度发送器
2.
Coupled analysis on flow field-temperature distribution of aircraft-skin
飞行器表面三维流场与固壁温度场的耦合分析
3.
The Analysis and Optimization of the Surface Temperature's Uneven Distribution of Two Deck Dryer
双层烘缸表面温度分布不均的分析和优化
4.
Study on the Temperature Change of the Ring Path of the Internal Surface of the Frozen Wall after Moldings
砌壁后冻结壁内表面环向温度变化特征分析
5.
thermocouple surface temperature sensor
热电偶表面温度传感器
6.
INVESTIGATION OF ENGINE TRANSIENT REGIMES THROUGH MEASUREMENT OF CYLINDER CAP TEMPERATURES BY THE AID OF MICROCOMPUTERS
利用微机测量过渡工况下发动机汽缸盖温度的变化规律
7.
The temperature of the gas rises. In the issue it expands in the cylinder.
气体的温度升高，因而它在汽缸里膨胀。
8.
Design of multi-gas-distributing Steam Header with high difference in temperature and convective heat exchanger
多汽源高温差分汽缸和对流式热交换器的设计
9.
Development of a Temperature Transmitter Based on DeviceNet Fieldbus;
基于DeviceNet总线的温度变送器的开发
10.
Research and Design of Temperature Transmitter Communication Interface Based on DeviceNet;
DeviceNet温度变送器通信接口的研究与开发
11.
The Research and Development of WorldFIP Multi-channel Intelligent Temperature Transmitter
WorldFIP多通道智能温度变送器的研发
12.
Temperature and Humidity Transmitter Design and Application Based on EPA Specification
基于EPA标准的温湿度变送器开发
13.
Influence of Wall Temperature of Discharge Channel on Hall Thruster
放电通道壁面温度对Hall推力器影响的研究
14.
chromium-plated thin-walled steel cylinder liner
钢质薄壁镀铬汽缸衬套
15.
When tube wall strength can not bear inner steam pressure in the tube, blowout of low-temperature tube occurs.
当管壁强度无法承受管内蒸汽压力时，导致低温过热器管爆裂。
16.
Aluminum-copper alloy which when heat-treated has good strength at high temperature is used for making pistons and cylinder heads for automobiles.
由于铜铝合金经过热处理之后具有良好的高温强度，所以用来制造汽车发动机的活塞与汽缸头。
17.
Research on Temperature Field Measurement System of Diesel Engine Head and Cylinder Sleeve
柴油发动机缸盖、缸套温度场测试系统研究
18.
Moto parts major in Iveco fitting，C.V boot, flasher, Distributor cap, Gasket and so on.
汽配方面主要有白金、防尘套、闪光器、汽缸垫等。