1.
Simulation and Driving Torque Experimental Research of the Electronically Controlled Cylinder Lubricator
电控气缸注油器仿真与驱动扭矩试验研究
2.
The Design and Study of Electronic Control System of Cylinder Lubricator for Marine Two-stroke Engine;
船用二冲程柴油机电控气缸注油器控制系统的设计与研究
3.
Air regulator, with two cups, reduce the rust for the cylinder and lubricate the cylinder.
油雾器，采用双杯油雾器，即可减少水对气缸的锈蚀又能起到润滑气缸的作用。
4.
Testing and Simulation on Performance of a New Type of Single-Cylinder Diesel Engine Exhaust Muffler
单缸柴油机新型排气消声器试验与仿真研究
5.
The carburetor delivers a rich mixture to the precombustion chamber and a lean mixture to the main cylinder.
化油器将浓混合气输至副燃烧室，将稀混合气输送至主气缸。
6.
mounded liquefied petroleum gas bullet tank
堆土式子弹形石油气缸
7.
Quality Optimization of Cylinder Bore Surfaces for TJ376Q Gasoline Engines;
TJ376Q汽油机气缸体缸孔加工质量优化
8.
On a typical in-line six-cylinder engine the carburetor is located on the intake manifold between cylinder 3 and 4.
在标准的六缸直列式发动机上，化油器被设置在进气歧管上3号和4号缸之间。
9.
Acoustic Performance Simulation Analysis and Experiment Study for Exhaust Muffler of Four-Cylinder Diesel;
四缸柴油机排气消声器声学特性仿真分析及试验研究
10.
What comes out of the carburetor is a fine fog of gasoline and air mixed. This gasoline fog is forced through some valves to the top of the cylinders.
从化油器出来的已是油气混合的薄雾。这些油雾通过一些阀门进入汽缸顶部。
11.
APPLICATION OF BALL ROLLING TECHNIQUE TO THE PROCESS OF CYLINDER
滚珠滚压工艺在油(气)缸缸筒加工中的应用
12.
The Numerical Simulation of Flow and Temperature Field in Cylinder Head of Diesel Engine with Small Cylinder Bore;
小缸径柴油机气缸盖流场、温度场的数值模拟
13.
Research on Measuring Method of Maximum Cylinder Compression Pressure for Multi-cylinder Diesel Engine
多缸柴油机最大气缸压缩压力测试方法研究
14.
Design of Injection Mold with Auto-Stripping Inner and Outer Screw Mechanism By Oil Cylind
油缸式自动内外螺纹脱模注射模设计
15.
FUEL INJECTOR SENSOR (NUMBER 1 CYLINDER ONLY)
燃油喷射器感知器（仅针对1号汽缸）
16.
What should be paid attention to in the overhaul of cylinder?
在气缸大修过程中应该注意什么？
17.
The cylinder be get too much gas and not enough air
汽缸里汽油太多而空气不足
18.
testing method for oxidation characterstics of cylinder oils
气缸油氧化稳定性能试验方法