1.
To avoid this discharge, install a spring-loaded, rubber seated check valve ahead of the backflow assembly.
为了避免这种排放，要在防回流阀总成前面安装一个弹簧驱动、橡胶阀座的止回阀。
2.
Finally, when the other sides of the spacer bars almost move to the press pulley, which will move up and automatically stop its gluing operation.
等间隔框另一侧快要到达压轮时，压轮抬起，离开打胶头时，胶阀自动关闭，停止打胶。
3.
The diaphragms may become permanently inverted and the elastomeric stem tip can cold flow down the throat of the valve.
横膈膜会永久性的翻转，人造橡胶阀杆尖端会冷变形到阀门的喉管处。
4.
To reverse the seat disc, unscrew the disc screw and disassemble the disc washer and disc rubber from the disc holder assembly.
为了翻转阀座阀瓣，则要拧松阀瓣螺丝，从阀瓣固定器总成拆解阀瓣垫圈和阀瓣橡胶。
5.
In order to gain access to the seat and clapper rubber ring, you must compress the spring (#3) that surrounds the clapper shaft (#1).
为了接近阀座和阀瓣橡胶环，必须压缩环绕阀瓣轴（1号）的弹簧（3号）。
6.
Application of Steam Pressure Reduction Valve in Sulfuration System of Textile Rubber Accessories
蒸汽减压阀在纺织橡胶器材硫化系统中的应用
7.
Development of Servo and Proportional Valve Controller for Internal Rubber Mixer;
密闭式炼胶机比例伺服阀控制器的开发
8.
The development of gel VRLA batteries for E-bikes
电动助力车用胶体阀控式铅酸蓄电池的研制
9.
A and B component glue pump, gelatinize gun and safety valve are all from GRACO Company of America. So it can ensure the credulity working.
A组份胶泵和B组份胶泵、胶枪、全阀均采用美国格瑞克（RACO）司产品，确保工作可靠。
10.
Position sensor to throttle body while guiding rubber fitting over throttle body vacuum nipple.
在节气阀体真空管接头上面操纵橡胶管件时，定位感知器至节气阀体。
11.
All butterfly valves may incorporate the use of silicone in either grease or aerosol form during the assembly.
在组装期间，所有蝶阀都可能接触到润滑脂或气溶胶喷射中的硅酮。
12.
These valves will be assembled not using silicone in the form of grease or aerosol spray.
这些阀门将在润滑脂或气溶胶喷射中不采用硅酮。
13.
The sealing disc may be reversed and reinstalled if the elastomer is cut or damaged.
如果合成橡胶有被割伤或损坏，则密封阀瓣可以反向并重新安装。
14.
XD-JB1.1style is non-automatic-controlled piston glue pump.
1型属于它控式活塞胶水泵，它由电磁阀控制气压驱动的频率。
15.
Biological effect of artificial bile duct combined with bionic valve made by fluoroelastomers-246B following implantation in dogs
氟橡胶246B制成仿生阀门人工胆管植入犬体内的生物学效应
16.
discharging valve
排出阀排气阀排水阀
17.
Type of valve- gate, globe, check, etc.
阀门种类：闸阀，截止阀，止回阀，蝶阀，球阀，等等。
18.
This is a gate valve (check valve, butterfly valve, cut-off valve, magnetic valve, remote valve, relief valve, throttle valve, cock).
这是一个闸阀（止回阀、蝶阀、切断阀、电磁阀、遥控阀、安全阀、节流阀、旋塞）。