1.
piston cooling gland
活塞冷却填料函压盖
2.
expansion gland
膨胀接头的填料压盖
3.
Gland Eye Bolts: Eyebolts swing aside for ease in repacking the stuffing box.
压盖有眼螺栓：有眼螺栓可以从旁边旋起，使得填料函的填料更换更加容易。
4.
cooling water piping complement for pisto
活塞冷却水管系总成
5.
lubricating oil and piston cooling oil pump
润滑油及活塞冷却油泵
6.
Effect of Cooling Oil-antrum Position on Intensity of Diesel Engine Piston
活塞冷却油腔位置对活塞强度的影响
7.
Gland– two piece gland bushing/ packing flange is self-aligning to prevent stem damage for cocked gland.
填料压盖-两件式填料压盖衬套/料法兰能够自动校准，以防止由于填料压盖翘起造成阀杆损坏。
8.
No packing gland, packing only in these sizes.
没有填料压盖，在这些通径的阀门里只有填料。
9.
With the heater control unit in the HEAT position, operate engine with coolant tank cap tightene
让加热器控制单元处于HEAT（加热）位置，旋紧冷却剂贮藏箱填压力/排气盖之后操作引擎。
10.
Applications software development of packing performance test platform for cooling tower
冷却塔填料性能测试台应用软件开发
11.
Optimized Design of G32 Diesel Engine Piston Crown
G32柴油机活塞头冷却结构的优化设计
12.
Plastic shrinks during cooling. Holding packs more material in to take up the shrunk space so the preforms are without sink marks.
在冷却时间内，塑料不断收缩，而保压填补收缩了的空间，使瓶坯饱满，不会下陷。
13.
Equally distributed gland bolts provide uniform compression of packing.
均匀分布的压盖螺栓为填料提供均匀的压力。
14.
Stainless steel stuffing box hardware is standard (ie. bolts, gland studs, nuts, washers).
标准的金属密封不锈钢填料箱（如螺栓、填料压盖螺栓、螺母、垫圈）。
15.
The drip type cooler is a fan unit with evaporative pads.
滴水式冷却器是一个带有蒸发填料的风机装置。
16.
Evaluating the performance of packing used in direct evaporative-cooling AHU.
直接蒸发冷却式空调机用填料的性能评价
17.
Study on the Thermal Performance of Packing in the Closed Counterflow Cooling Tower
逆流密闭式冷却塔淋水填料层热工性能的研究
18.
Thermal characteristic analysis of regular stuffing spray air coolers
规则纸填料淋水式空气冷却器热工特性分析