1.
opening diagram of fuel valve needle
喷油器针阀的开启图
2.
delayed-action time of discharge
喷射滞后时间灭火器的控制阀门开启或达到相应的开启状态时起
3.
needle valve of economizer
（汽化器内）省油针阀
4.
Design of Digital Fuel Quantity Measurement Used on Test Bench of Fuel Injection Pump Based on Needle Valve Lift;
基于针阀升程的喷油泵试验台数字化量油系统的设计
5.
With the regulator adjusting knob turned fully counterclockwise, place both hands on the cylinder valve and open it slowly, allowing the pressure to rise gradually in the regulator.
调整器的调节钮逆时针旋死后，两只手放在钢瓶阀门上，慢慢地开启，使调整器内的压力逐渐增加。
6.
Switch on the ignition, close the choke and suck gas into the intake of the carburetor by flipping the propeller over counter-clockwise.
打开点火系统电源,关闭阻气阀逆时针拨动螺旋桨让油进入化油器。
7.
Finite Element Analysis on 3D Flow in the Nozzle and Shock Stress of the Needle in Diesel Engine Injector;
柴油机喷油嘴三维流场及针阀碰撞有限元分析
8.
Stand clear of the regulator and valve outlet, while opening the valve.
开启阀门时，躲开调整器和阀门排气口。
9.
The Study and Design of NC Machining Spiral Groove of the Needle Valve Fuel Injector;
喷油嘴针阀螺旋槽加工数控系统研究与设计
10.
Fuel Injector Line At Injector
在喷油器处的燃油喷油器管线
11.
Improved Design and Experimental Study on Solenoid Valve Drive Circuit for Electronically Controlled Injector
电控喷油器电磁阀驱动电路的改进设计及试验研究
12.
FUEL INJECTOR SENSOR (NUMBER 1 CYLINDER ONLY)
燃油喷射器感知器（仅针对1号汽缸）
13.
The accelerator pump injected fuel into the inlet air when the throttle was opened suddenly.
节流阀突然打开时,加速泵将更多的燃油喷入吸进的空气中。
14.
Close the regulator. To close the regulator, turn the adjusting knob to the full counter-clockwise position. The regulator must be closed before opening the cylinder valve.
关闭调整器。要关闭调整器，把调整钮逆时针旋死。在开启钢瓶阀门之前，必须关闭调整器。
15.
ASIMCO TianWei exports Diesel Pumps, Injectors, Nozzles, Plungers and Valves, Auto Part machining.
亚新科天纬的出口产品包括：喷油泵、油器、油嘴、塞、油阀、车零部件加工类。
16.
blowing the drip
打开集液器阀门让天然气喷放
17.
Open needle valve" A" high side and vent needle valve to vent air from bypass hose.
开启针形阀“A”高端和排气针形阀，从旁路软管排放空气。
18.
Researchs on the Development of Color Inkjet Plotter Controller;
彩色喷墨绘图仪控制器的研制和开发