1.
measurement of fit clearance of propeller
![点击朗读](/dictall/images/read.gif)
螺旋桨轴安装间隙测量
2.
Research on the Online Measurement System of Product Gesture and Aassembly Interval;
![点击朗读](/dictall/images/read.gif)
产品装配间隙及姿态在线测量系统的研究
3.
steering wheel clearance checking scale
![点击朗读](/dictall/images/read.gif)
转向盘自由间隙测量器
4.
Measure bearings for correct clearance
![点击朗读](/dictall/images/read.gif)
测量轴承以校正间隙
5.
Install rings and confirm ring side clearance:
![点击朗读](/dictall/images/read.gif)
安装活塞环,并确认活塞环侧间隙:
6.
Measuring Outer Rotor Clearance in Housing
![点击朗读](/dictall/images/read.gif)
在机壳中测量外转子间隙
7.
New method of measuring the clearance between bush sleeves and diesel engine rod without disassembly
柴油机连杆轴瓦间隙不拆卸测量方法
8.
Research on Measurement of Dynamic Gap of Gas Turbine Based on FPGA
![点击朗读](/dictall/images/read.gif)
基于FPGA燃气轮机动态间隙测量的研究
9.
Experiment Research of the Tip Clearance Measurement by Digital Radiography
![点击朗读](/dictall/images/read.gif)
转子叶尖间隙辐射成像测量实验研究
10.
A visual check of air gaps is sufficient, but mechanical backflow preventers have to be tested with properly calibrated gauge equipment.
尽管安装气隙足够目视观察,但是机械式防回流阀还是必须用适当量程的仪表设备进行检测。
11.
Care must be taken during installation so that the Flow Measurement Device fitting is concentric with the center line of the pipeline in which it is installed.
在安装期间必须小心,使得流量测量装置的中心与所安装的管线中心对齐。
12.
Narrow and Small Curved Surface Level Gap Optical Fiber Bragg Grating Measurement System Development;
狭小曲面层间间隙光纤光栅测量系统的研制
13.
Test method for determination of radial interstitial oxygen variation in silicon
![点击朗读](/dictall/images/read.gif)
GB/T14144-1993硅晶体中间隙氧含量径向变化测量方法
14.
Study on the Detection & Controling of the LSWEDM Gap State Energy
![点击朗读](/dictall/images/read.gif)
慢走丝线切割加工间隙能量测量与控制的研究
15.
Narrow and Small Surface Temperature and Gap Optical Fiber Bragg Grating Measurement System Development
狭小曲面下温度和间隙双参量测量的光纤光栅测量系统的研制
16.
A New Method of Measuring the Clearance Between Bush Sleeves and Diesel Engine Rod without Disassembly
柴油机连杆轴瓦间隙不拆卸测量方法仿真研究
17.
3D-PIV Measurements in Clearance between the Impeller and the Diffuser of an Axial Flow Pump;
轴流泵叶轮与导叶轴向间隙内流场的3D-PIV测量
18.
Implemention of Gap Determination Module for High-Speed Maglev Vehicle Based on FPGA;
![点击朗读](/dictall/images/read.gif)
高速磁浮列车悬浮间隙测量模块的FPGA实现