1.
Under working conditions the pressure difference should not exceed the full-scale value of the gauge.
在工作时，压差不应该超过压力表的量程值。
2.
The High-temperature-proof pressure gauge is mainly used in chemical、 petroleum industries for measuring pressure of high temperature media under high temperature environment.
耐温压力表具有氨用压力表的使用性能，主要用于化学、油工业中高温介质或环境压力测量。
3.
resistance head
阻力压头(用压头表示的阻力损失)
4.
Surface tension makes the pressure inside a bubble exceed the pressure of its surroundings.
表面张力使气泡内的压力超过其环境的压力。
5.
pounds per square inch gauge [psig]
磅／平方吋表压力〔表压〕
6.
There is compliance in indication between the pressure gauge (X) and the pressure gauge mounted on the pressure reducing valve (28).
有依从指示在压力表X和安装在减压阀28的压力表之间。
7.
The postion for fitting-up this kind of gauge and what to be dine with care are the same as verdsatile gdauges.
仪表上的压力表安装位置和注意事项均与普通压力表相同。
8.
INSTALL A 0 TO 3PSI PRESSURE GAUGES ON THE OD AND UD PRESSURE PORTS.
在ＯＤ和ＵＤ的压力端口上安装Ａ０到３００ＰＳＩ压力量表。
9.
Water table is a surface on which the presure is atmospheric.
潜水面是一个其表面上压力等于大气压力的面。
10.
show/exercise great self-control in moments of stress
在有压力时表现出[运用]很强的自制力
11.
She has shown great resilience to stress.
她对压力表现出了极大的适应能力。
12.
Static pressure is the designed pressure difference within the pipeline between two testing points. It is a necessary date when selecting different types of pressure gauges.
静压是差压表两个检测点所在管道内的设计压力。它是差压压力表选型时必需的数据。
13.
Duplex (pressure)gauge
双工[双针]压力表
14.
But he said funding strains remain high and balance sheet pressures on financial institutions continue.
但他表示：“资金压力仍然很大，金融机构的资产负债表压力依然存在。”
15.
In chemical industry, the instrument used to measure absolute pressure can't gain relative pressure immediately, the relative pressure can only be gained by calculation.
在化工行业中常常需要测量压力值,目前使用的压力表只能测绝对压力值,而不能测相对压力值。
16.
The measure of pressure at the lower point expressed in terms of this difference.
压差用落差表示的在较低点所测量出的压力
17.
Automatic Verification System of Aviation Barometric Altimeters Based on PPC2 Pressure Controller
基于压力控制器的气压高度表自动检定系统
18.
Flat seating faces for low and medium pressures.
适用于中低压力的平面阀座表面。