1.
Make Contact;Break Contact;Symbol 3;Symbol 4
闭合触点;断路器触点;符号 3;符号 4
2.
Make contact (normally open) with time delay.
具有时延作用的闭合触点(正常情况下为断开)。
3.
make before all others operate
其他触点都动作前闭合
4.
make after all others operate
其它触点都动作后闭合
5.
Make-before-break, shorting (bridging) during contact transfer.
断开前闭合, 触点切换期间短路（桥接）。
6.
"A feeler gauge, a dial indicator or a cam-angle meter can be used to test the amount of contact-point opening."
测隙规、千分表或触点闭合角测定表也可检测触点开度。
7.
Break contact (normally closed) with time delay.
具有时延作用的断开（正常情况下为闭合）触点。
8.
The signals can occur at anytime, but board transfer dose not occur until both contacts are closed.
信号随时产生，但板的传送必须在两个触点均闭合时方可产生。
9.
An unwanted making and breaking of the connection while opening or closing a contact.
一触点在断开或闭合时造成的一种不希望产生的断断续续的连接状态。
10.
current-on contact
开关［触点］电流， 合闸电流
11.
Of a selector, a moving contact that engages with the contacts of a bank.
与存储单元的触点相啮合的选择器滑动触点。
12.
Clinical application of StarClose vascular closure device in the closing of femoral artery puncture site
StarClose血管闭合器封闭股动脉穿刺点的临床应用
13.
travelling contact
动接触， 活动触点
14.
Rational Determination of Elastic Gasket Contact Stress and Closure Pressure for Shield Tunnel Segments
隧道管片密封垫接触应力和闭合压力的合理确定
15.
dot alloy mesa transistor
点接触合金台面型晶体管
16.
When coolant goes through ON/ OFF devices, contact surfaces automatically closes to prevent leakage. Contact surfaces automatically detaches from each other upon exhaustion of coolant to avoid dry grinding.
当冷却剂穿越开/机构时，接触面自动闭合防止洩漏，冷却剂终止时接触面马上打开、免乾磨擦。
17.
Male Female contact. Contact types can be specified.
插头触点和插孔触点。可指定触点类型。
18.
To consistently be vertical at contact, remember that the racquet face should be closed with the non-hitting hand at the low point of the backswing.
为了在接触点要一致性地保持垂直，记得非打击的手在背后拉拍的低点而网拍面应该是关闭的。