1.
Building berth is the fixed ground support and launching-cradle is only used before launching. The latter will be sliding together with the ship into the water.
船台是固定的地面支撑，下水支架仅用于下水时用。后者在下水时与船体一起滑入水中。
2.
One of the beams of a launching cradle supporting a ship's hull.
用于支撑船体的下水架上的一横梁
3.
Disconnect water piping connections to the cold water inlet and the hot water outlet. Disengage the heater from the wall bracket.
在冷水和热水接口处拆下水管。从墙支架上拆除热水器。
4.
Optimizing for Levels and Structure of Agricultural Domestic Support Under the Frame of WTO in China;
WTO框架下我国农业国内支持水平与结构优化
5.
A supporting framework or structure, as for the body of a motor vehicle.
底架，下架机动车辆下的支架或支撑结构
6.
Position a support under skid plate.
在滑板下定位一个支架。
7.
LEFT ENGINE MOUNT BRACKET LOWER BOLTS
左引擎固定支架下螺栓
8.
Remove the accumulator from the support bracket.
从支架上拆下蓄压器。
9.
Analysis and Calculation for Launching of ship without Forward Cradle
船舶无首支架纵向下水新工艺的力学分析与计算
10.
Elastoplastic Ultimate Bearing Capacity Analysis of the Steel Pipe Falsework under Horizontal Load
水平荷载作用下钢管支架的弹塑性极限承载力分析
11.
Position the lower suspension arm at the axle bracket and rear bracket.
把下端悬吊臂放在车轴支架和后侧支架上。
12.
"Boosters may be under-counter mounted with slide out hangers or free standing on 6"adjustable legs."
电热水加热器可以安装在台面下的滑动支架上,或靠6英寸可调节柱脚支撑的自由安装。
13.
The horizontal supports Beneath its top surface-and the vertical supports into which they frame-must be sufficiently large and spaced closely enough to prevent sagging of the assembly.
在顶面下方的水平支撑以及框架的垂直支撑必须足够,间隔紧密以防止构件弯曲。
14.
THE AFFECTION OF REINFORCED CONCRETE FRAME STRUCTURE SUFFERED LONGITUDINAL HORIZONTAL EARTHQUAKE ON TRANSVERSE HORIZONTAL STRUT OF ROOF
钢筋混凝土框排架结构在纵向水平地震作用下对屋盖横向水平支撑的影响
15.
A horizontal beam or bar held up by two pairs of divergent legs and used as a support.
支架一根水平的起支撑作用的梁子或木棍，用两对叉开的支脚支撑
16.
sawhorses used in pairs to support a horizontal tabletop.
把两个支架放在一起来支撑一个水平的桌面。
17.
Research on Supporting Density of Powered Support for Full-mechanized Caving Ming in Shuiliandong Colliery
水帘洞煤矿综放工作面支架支护强度的确定
18.
Discussion on the Hydraulic Parameters of Bearing Prong in Long-axial Pump for Deep Well;
长轴深井泵轴承支架水力参数的探讨