1.
They act as small laminated springs and keep the belt strap flat.
它们可以充当小小的叠片弹簧，让安全带保持平整度。
2.
a pocketknife with a spring-operated blade.
有弹簧折叠刃片的小刀。
3.
Study on Superposition Throttle-Slice and Opening Valve Pressure of Hydro-pneumatic Spring
油气弹簧多片叠加节流阀片与开阀压力研究
4.
Design Methods of Superposition Throttle Slices and Influence on Throttle Aperture of Hydro-Pneumatic Spring
油气弹簧叠加阀片设计方法及对节流缝隙影响
5.
folded cantilever contact
折叠悬臂式触点簧片
6.
spring loaded apex seal
弹簧加载径向密封片
7.
Leaf Spring Remove/Install
叶片弹簧之拆卸、安装
8.
"There are two types of leaf spring, the multileaf and the single leaf."
钢板弹簧有两种,多叶片钢板弹簧和单叶片钢板弹簧。
9.
Tighten leaf spring press until bushing is extracted from leaf spring.
上紧叶片弹簧加压机直到衬套被拔出叶片弹簧。
10.
Clutch Type Single sheet, dry type, film spring
离合器型式：单片、干式、膜片弹簧
11.
Elastic damping leaf coupling
GB/T12922-1991弹性阻尼簧片联轴器
12.
Elastic damping leaf damper
GB/T14654-1993弹性阻尼簧片减振器
13.
Fracture Failure Analysis of Pressing Spring for Rearview Mirror
汽车后视镜压入弹簧片断裂失效分析
14.
The Design of Diaphragm Spring Clutch
膜片弹簧式离合器的分析及优化设计
15.
"Cushion springs. If the cushion springs under the facings appear to be cracked or weak, the friction disk should be replaced."
缓冲弹簧:如果衬片下的缓冲弹簧出现裂纹或磨损,摩擦盘也应更换.
16.
"Three types of clutch are the coil-pressure-spring type, diaphragm-spring type, and semi centrifugal type."
离合器的三种类型为:螺旋弹簧式,膜片弹簧式和半离心式。
17.
Influence of Elastic Modulus toValves Designing Parameters of Hydro-Pneumatic Spring
阀片弹性模量对油气弹簧阀系设计参数的影响
18.
Produce primarily now the every variety spring, spring layered, rammed res and divided by the iron tool product.
现主要生产各类弹簧、簧片、金冲压件及除铁工具产品。