1.
hose connection valve
软管联结阀软管连接阀
2.
Remove the relief valve hose from fitting below inlet ball valve.
从进口球阀下面连接件拆卸安全阀软管。
3.
Connect vacuum hose to booster check valve.
连接真空软管到增压器检测阀。
4.
Connect a hose to the drain valve and terminate it to an adequate drain.
用一条软管将排污阀连接到适当的排污口处。
5.
Connect bypass hose between vent needle valve and loosely connect to test cock No.1.
在排气针形阀上连接旁路软管，并将其松散连接到测试旋塞1号上。
6.
Connect vacuum line to EGR valve.
将真空管路连接到EGR阀。
7.
Grooved butterfly valves direct connect to pipe using iron pipe size couplings. Grooved valves are easiest to install.
管状蝶阀:采用铸铁管接头直接与管道连接。管状阀门安装最容易。
8.
Connect brake booster hose.
连接刹车增压器软管。
9.
Connect the lower radiator hose.
连接下侧散热器软管。
10.
clamp hose connectio
用夹子夹住的软管连接
11.
Loose connections in the valve solenoid circuits
在阀螺线管电路中松散的连接
12.
Install brake lines that connect master cylinder to combination valve.
安装连接总泵至组合阀的煞车管线。
13.
Models8 A,8 B,8 FR and8 P hose connection vacuum breakers are constructed to allow sill cocks to be drained.
型号8A,8b,8FR和8P软管连接真空断路阀其b>结构b>允许洒水龙头排放。
14.
Simply remove hose coupling and lightly pull knurled tip of stem at outlet of valve to allow drainage of collected water.
只需简单地拆卸软管连接并轻轻拉法门出口处阀杆有刻纹的末端，使残留水排放出来。
15.
"Valve Stand: Support air supply header and various takeover points, flex hoses, gauges, valves, etc."
阀架上面安架空气接头,各种转换点,软管,计量表,阀门等。
16.
4"H.T. Hose Connection which easily attaches to an outside hose bibb or to the drain connection on a water heater.
软管连接，容易连接到外置软管水龙头或热水器的排放接头。
17.
Connect the air inlet hose to the throttle body and the air cleaner.
将空气入口软管接至节流阀体和空气滤清器。
18.
Reattach the relief valve hose to the elbow in the bottom flange cover.
重新将安全阀软管接到底部法兰盖内的弯头上。