1.
hose connection valve
软管联结阀软管连接阀
2.
Remove the relief valve hose from fitting below inlet ball valve.
从进口球阀下面连接件拆卸安全阀软管。
3.
Disconnect the hose from the bottom cover plate to the relief valve.
断开底部盖板到安全阀上的软管。
4.
Connect vacuum hose to booster check valve.
连接真空软管到增压器检测阀。
5.
Application of Sleeve-valve Pipe Grouting Technology on Soft Soil Foundation Treatment
袖阀管注浆工艺在软基处理中的应用
6.
Models8 A,8 B,8 FR and8 P hose connection vacuum breakers are constructed to allow sill cocks to be drained.
型号8A,8b,8FR和8P软管连接真空断路阀其b>结构b>允许洒水龙头排放。
7.
Research on Dual-Chamber Tandem Piezoelectric Pump of Combination of Active and Passive Valves
主被动阀结合的双腔串联压电泵研究
8.
triple valve nipple
三通阀与辅助风缸联接短管
9.
Open needle valve" A" high side and vent needle valve to vent air from bypass hose.
开启针形阀“A”高端和排气针形阀，从旁路软管排放空气。
10.
"Valve Stand: Support air supply header and various takeover points, flex hoses, gauges, valves, etc."
阀架上面安架空气接头,各种转换点,软管,计量表,阀门等。
11.
Application of Inventor in the Structure Design of Electric Control Valve
INVENTOR软件在电动式调节阀结构设计中的应用
12.
Connect a hose to the drain valve and terminate it to an adequate drain.
用一条软管将排污阀连接到适当的排污口处。
13.
Remove the air inlet hose from the throttle body and air cleaner.
从节流阀体和空气滤清器上拆下气流入口软管。
14.
Connect the air inlet hose to the throttle body and the air cleaner.
将空气入口软管接至节流阀体和空气滤清器。
15.
Reattach the relief valve hose to the elbow in the bottom flange cover.
重新将安全阀软管接到底部法兰盖内的弯头上。
16.
The Design and Development of Production Management Software on Dynamic Flow Balance Valves
动态流量平衡阀生产管理软件的设计与开发
17.
Using a hose pinch-off pliers (C-4390), pinch power steering oil return hose off between the crossmember coupling and the pump.
使用软管夹紧钳(C-4390)，夹紧介于横梁联结与油泵之间的动力转向系统回油软管。
18.
Research of Hose Invalidation Factor and Improvement of Hose Pump Structure;
软管泵软管失效因素研究及软管泵结构改进