1.
When ordering a floor stand - the dimension from the centerline of the valve waterway to the top of the floor must be furnished.
订购地轴架时,请提供从阀门水路中心线到地面的距离尺寸。
2.
"Floor stands are designed for operating gate, globe and angle valves that are installed in inaccessible places under a floor."
为了操作那些安装在地下、难于接近的闸阀、截止阀和角阀,我们设计了地轴架。
3.
The NIBCO valve figure number and size must also be furnished and specify valve stem coupling for use with floor stand.
另外还要提供尼伯科阀门型号和尺寸,并说明所要采用的阀门阀杆与地轴架的连接装置。
4.
These two floor stands also available with an indicator so the position of the disc (wedge) can be read at a glance.
这两种地轴架都可配置指示器,因此只要看一眼就能够知道阀瓣(楔板)的位置。
5.
If the first axis is perpendicular to the ground we speak of an azimuthal mounting.
如果第一根轴与地面垂直，就称为地平式支架。
6.
cageless bearing
无保持架轴承,开口轴承
7.
A frame for holding bobbins or spools in a spinning machine.
轴架纺纱机里用来固定线轴的柜架
8.
The pin on which a gun carriage revolves.
炮架枢轴炮架转动用的枢轴
9.
side bearing arch
中摇枕(三轴转向架)
10.
center bearing anchor bar
中摇枕拱板(三轴转向架)
11.
Camshaft Holder C-3509
凸轮轴保持架C-3509
12.
non-axial type gear
无轴式传动装置[起落架]
13.
The carriage is supported on guide shafts.
托架支承在导轴上。
14.
Remove thrust bearings from rear main bearing carrier.
从后主轴承托架上拆下止推轴承。
15.
Discussion on the Hydraulic Parameters of Bearing Prong in Long-axial Pump for Deep Well;
长轴深井泵轴承支架水力参数的探讨
16.
semimajor axis of ellipsoid
椭球长半轴，地球长半轴
17.
Measuring and Analyzing the Residual Stress of the Principal Axis Bearing Racks of 1.5 MW Wind Power
1.5MW风机主轴轴承架残余应力的测量及分析
18.
Position the lower suspension arm at the axle bracket and rear bracket.
把下端悬吊臂放在车轴支架和后侧支架上。