1.
Auto-generation algorithm of outside cable match drawing based on cable route graph in railway signal engineering design
铁路信号基于电缆径路图自动识别的室外电缆配线图生成算法
2.
C battery substation
变压器室电缆汇接间
3.
Aluminum conductor XLPE insulated low-smoke and non-halo sheathed Flame-retardant power cable.
室内、隧道及电缆沟等不能承受机械外力的场所。单芯电缆不允许敷设在磁性管道中。
4.
For laying in doors、intunnels and in cable trench, able to berar external mechanical forces, but unale to bear large pulling force.
室内、隧道、电缆沟等能承受机械外力的场所，但不能承受大的压力。
5.
For laying indoors, in tunnel, cable french, well or direct in ground, able to bear external mechanical for ces and certain pulling force.
室内、隧道、电缆沟、竖井或埋地敷设等，能承受机械外力和一定的拉力。
6.
Aluminum conductor XLPE insulated fine steel wire armored low-smoke and non-halo sheathed Flame-retardant power cable.
室内、隧道、电缆沟、竖井等能承受机械外力和一定拉力的场所。
7.
For laying indoors,in trenchesin ducts and in ground,able tobear heavier pulling force,andfor fixed installation.
敷设在室内、电缆沟、管道、直埋等能承受较大机械外力等固定场合。
8.
The bending radius should not less than25 times of cable diameter.
电缆弯曲半径：不小于电缆外径的25倍。
9.
Protective coverings for electric cables-General
GB/T2952.1-1989电缆外护层总则
10.
Protective coverings for electric cables-Specific protective coverings for oil-filled cables with lead sheath
GB/T2952.4-1989电缆外护层铅套充油电缆特种外护层
11.
Protective coverings for electric cables-General protective coverings for cables with non-metallic sheath
GB/T2952.3-1989电缆外护层非金属套电缆通用外护层
12.
Protective coverings for electric cables-General protective coverings for cables with metallic sheath
GB/T2952.2-1989电缆外护层金属套电缆通用外护层
13.
Calculation of the laying-up diameter of LV power cables by the gradual degeneration method
两端极限法计算低压电力电缆成缆外径
14.
hank of cable
电缆盘, 一盘电缆
15.
For laying indoors、in tunnel, cable trench, or direct in ground, able to bear external mechanical forces, but unable to bear large pulling force.
室内、隧道、电缆沟内或埋地敷设等，能承受一定的机械外力，但不能承受大的拉力。
16.
For laying in doors, in tunnels, in cable trench or direct in ground, able to bear external mechanical forces, but unable to bear large pulling force.
室内、隧道、电缆沟内或埋地等能承受机械外力的场所，但不能承受大的拉力。
17.
This cable has a rubber casing.
这根电缆线外包有一层橡胶。
18.
insulating machine for electric cable (excl. gimping machines)
电缆绝缘层加工机（嵌心狭辫带机除外）