1.
Experimental Study on Warpage of Flat Part with Reinforced Rib by Gas-assisted Injection Molding
气体辅助注塑成型带加强筋平板的翘曲试验研究
2.
There's a warp in the board.
这块木板有点翘曲不平。
3.
Warpage of Three-Dimensional Multi-Chip Module Based on Embedded Substrate
基于埋置式基板的三维多芯片组件的翘曲研究
4.
Twisting arises in boards through the presence of spiral or interlocking grain.
翘曲多发生在螺旋或交错纹理的板材中。
5.
Analysis of the Effects of Temperature Warping Deformation on Base
路面板温度翘曲变形对基层的作用分析
6.
Research on the Head Bending of Plate Rough Mill Based on Dynamic Explicit FEM;
基于显式动力学有限元的中厚板粗轧头部翘曲的研究
7.
Modelling Semi-Rigid Composite Joints with Precast Hollowcore Slabs in Hogging Moment Region
对翘曲弯矩区域内的预制空心板的半刚性组合节点建模
8.
warping coefficient
(混凝土路面的)翘曲系数
9.
Test methods of platness for printed boards
GB/T4677.5-1984印制板翘曲度测试方法
10.
Experimental Research and Theory of Slab Head Bending in Rolling Processing;
中厚板轧制头部翘曲理论与实验研究
11.
In actual car service of such batteries, the two outside positive plates were generally buckled and shorting through the adjacent separators.
这种蓄电池在实际车辆使用过程中，一般都是外面两片正极板翘曲，穿透相邻的隔板而造成短路。
12.
The condition of having an arched surface.
翘曲表面弯曲的这种状况
13.
Curing Shrinkage and Warpage Deformation of Composite Thin Laminates at Room Temperature
复合材料薄层板常温固化收缩及翘曲变形
14.
The deeper structure appears to be a gently warped monocline.
较深构造仿佛是轻度翘曲的单斜。
15.
Experimental Research and FEM Simulation of the Slab Head Bending;
轧件头部翘曲的实验研究与数值模拟
16.
Topology Optimization of Beam Cross Section Considering Warping Deformation;
考虑翘曲变形的梁截面拓扑优化设计
17.
Study on Warpage of Injection Products Based on CAE;
基于CAE技术的注塑制品翘曲变形研究
18.
Effects of process parameters on the warpage of gas assisted injection molded part
工艺参数对气辅注射制品翘曲的影响