1.
Investigation of Pressure Distribution of Partial Porous Aerostatic Thrust Bearing
局部多孔质气体静压止推轴承压力分布的研究
2.
The pressure distribution was simulated with a approximate method.
采用近似方法模拟径向滑动轴承压力场分布。
3.
pressure balanced bearing seal
压力平衡式轴承密封
4.
Pressure-compensated air bearings are used on both ends of the trunnion axis.
耳轴两端各用一压力补偿空气轴承。
5.
radial Bearing and thrust Bearing
横力轴承与推力轴承
6.
Ultimate Capacity of Axially Loaded Thin-Walled Tapered Columns with Doubly Symmetric Sections
双轴对称薄壁锥形柱轴心受压的极限承载力
7.
Compution on Pressure Distribution of Stern Bearing Liquid Film Reckoning in Inclination of Stern Shaft
计入艉轴倾角的船舶艉轴承液膜压力分布计算
8.
The Determination of the Critical Technical Supply Pressure of the Rubber Guide Bearing of the Axial Pump
轴流泵橡胶导轴承技术供水临界压力的确定
9.
The Influence Analysis on Precision of Press Caused by the Diameter Deviation of the Crank Supporting Neck
曲轴支承颈的轴径误差对压力机精度影响分析
10.
The Stability Analysis of the Axially Loaded Aluminum Alloy Pipe;
铝合金圆管轴心受压稳定承载力研究
11.
Study of Load Carrying Capacity of Cold-Formed Square Hollow Section Columns under Axial Load;
轴心受压冷弯方管柱承载力性能研究
12.
Buckling capacity optimization of cylindrical shell with rectangle stiffeners under uniform axial compression
矩形加筋圆柱壳轴压屈曲承载力优化
13.
Ultimate Bearing Capacity of FRP-Concrete Stub Columns under Axial Compression
FRP-混凝土轴压短柱的极限承载力研究
14.
Effect of axial compression ratio to bearing capacity of piece with T-shaped section
轴压比对T形截面构件承载力的影响
15.
Experimental Study on the Axial Compression Strength of CS Wall Slabs
CS墙板轴心受压承载力的试验研究
16.
Increasing total load-carring area of thrust blok in the thrust bearing, increasing cooling area, the load-carring ability has been improved
通过增加推力轴承的推力块总承压面积,增加冷却面积,提高了推力轴承的承载能力
17.
A Study on Characteristics of Air Static Pressure Thrust Bearing with Variable-Section Pressure Equalizing Groove
具有可变均压槽的气体静压推力轴承性能研究
18.
Pressure and Streamline Field Simulation Analysis of Ball Mill Hydrostatic Bearings
球磨机静压轴承静态压力场及流场仿真分析