1.
Measuring and Analyzing the Residual Stress of the Principal Axis Bearing Racks of 1.5 MW Wind Power
1.5MW风机主轴轴承架残余应力的测量及分析
2.
Drawing of Cold Stamping Process of Bearing Frame and Die Design
轴承架的冷冲压拉深工艺及模具设计
3.
cageless bearing
无保持架轴承,开口轴承
4.
Remove thrust bearings from rear main bearing carrier.
从后主轴承托架上拆下止推轴承。
5.
The carriage is supported on guide shafts.
托架支承在导轴上。
6.
Discussion on the Hydraulic Parameters of Bearing Prong in Long-axial Pump for Deep Well;
长轴深井泵轴承支架水力参数的探讨
7.
Mode and Finite Element Analysis of the Centrifugal Pump Bearing Bracket;
离心泵轴承支架的模态及有限元分析
8.
The Technical Research on Squeeze Casting of Magnesium Alloy Bearing Cage
镁合金轴承保持架挤压铸造工艺研究
9.
Analysis on the stripping method of planetary bearings of JOY shearer
JOY采煤机大行星架轴承拆解办法
10.
Design of Fillet Parameter of Needle-cage Assembly
滚针轴承保持架组件圆角参数的设计
11.
Improvement of tooling of electrical riveting cage for cylindrical roller bearing
圆柱滚子轴承保持架电铆合工装改进
12.
Research on Vibration Properties of Auxiliary Bearing Cage Used in HTR-10 GT Project
HTR-10 GT辅助轴承保持架振动特性研究
13.
Shaft Assembly (Male, female, washer, grease….
轴组件（轴，轴套，轴承，油脂。。。）
14.
These materials are suitable for fabrication of the cage of rolling contact bearings.
这些材料适宜于制造滚动轴承的保持架。
15.
Simple single yoke construction eliminates outside gearing and bearings.
简单的单轭架结构，避免采用外部齿轮和轴承。
16.
APPLICATION OF DU PONT NYLON 66 ENGINEERING PLASTICS IN THE BEARING HOLDER
杜邦尼龙66工程塑料在轴承保持架上的应用
17.
Design of main parameters in forming die of ribbon cage for 205 type bearings
205轴承浪形保持架整形模主参数的设计
18.
The Study of Oil-impregnated Porous Polyimide Retainers Used for Gyroscope Bearing;
陀螺轴承用多孔含油聚酰亚胺保持架研究