1.
Apply a thin coating of petroleum jelly or chassis grease to the exposed surfaces of the cable terminal clamps and the battery terminal posts.
为电缆终端线夹和电池接线柱露出部分涂一层薄的凡士林油或车用底盘滑脂。
2.
Connect these wires to the leads of the battery.
将这些导线接到电池的引线上。
3.
Connect yellow lead to battery power supply of car.
连接黄色导线到汽车的电池电源。
4.
The research and application of offline battery electronic power generation while Access Nework Devices is powered off
接入网设备停电后蓄电池离线发电研究与应用
5.
The receiver is hooked up through a bettery to wires B and C.
接收装置通过b>电池b>接在导线b和C上。
6.
The braided copper wire is suitable for the flexible conductor of electric installation, switch gear, electric frunace, storage battery, etc.
铜编织线用于电气装置，开关电器，电炉及蓄电池等的软连接线。
7.
Install the battery and connect the battery cable.
安装电池并连接电池电缆。
8.
Inserting the AC supply lead into the unit automatically disconnects the batteries.
交流电源导线连接本机时，机内干电池即自动切断。
9.
Ample space is provided on the radio tray for modern batteries, switches, amplifiers, governors, regulators, receivers, and wiring.
空间提供现代托盘上电台电池、关、大器、长监管接收机、线.
10.
Disconnect and isolate the battery negative cablUnplug the 2-way heated seat back wire harness connector.
断开并且绝缘电池负极电缆。拆下2路加热座椅垫线束接头。
11.
CONNECT A JUMPER BETWEEN THE BATTERY TEMP SENSOR SIGNAL AND SENSOR GND CKTS.
电池温度感知器信号和感知器接地电路Ｓ之间设一条跳线。
12.
As a result, the AC supply lead must be removed from the unit in order to operate the unit on battery power.
因此，如使用机内干电池，须将连接本机之交流电源导线拔去。
13.
radio B battery
无线电Ｂb>电池b>组
14.
battery trolley locomotive
蓄电池架线两用电机车
15.
trolley-cum-battery locomotive
架线蓄电池两用电机车
16.
Cable connections are made to the side of the battery by means of threaded bolts into "cast-in-lead" stainless steel nuts.
在蓄电池一侧，利用螺栓拧到“镶铸铝”的不锈钢螺帽上进行馈线连接。
17.
connect the two poles of battery
把电池的两极连接起来
18.
"When the horn winding is connected to the Battery, the magnetism produced by the winding pulls the diaphragm down, creating a loud click."
当喇叭线圈与蓄电池的电路接通时,喇叭线圈产生的磁力振动膜片,产生响亮的声音。