1.
DETERMINATION OF THE LENGTH OF THE CONTACT ARC IN COLD ROLLING AND CALCULATION OF THE ROLLING FORCE
冷轧板材接触弧长度的确定及轧制力计算
2.
k-and-wiper switch
触排和接帚开关;触排及弧刷转接器;双动选择器
3.
A study of the effect of contact strength on spiral bevel gears affected by contacting area etc
接触区等对弧齿锥齿轮接触强度影响的研究
4.
Tooth mesh and contact analysis of spiral bevel gears based on MATLAB
MATLAB环境下的弧齿锥齿轮啮合接触分析
5.
Contact Zone Simulation Analysis of Spiral Bevel Gear Teeth Faces in Heavy Load Transmission
重载弧齿锥齿轮齿面接触区仿真分析
6.
THE EFFECTS OF CONTACT DEFORMATION OF LINE-CONTACT CATT CYLINDER GEAR ON THE BENDING STRESS IN THE FILLETS
线接触圆弧齿线圆柱齿轮齿面接触变形对齿根应力的影响
7.
ON THE THREE DIMENSIONAL CONTACT STRENGTH OF FINAL ARC FIR TREE BLADE ROOT AND ROTOR
末级圆弧枞树型叶根与轮缘三维接触强度研究
8.
The Design of High Speed Globodial Cam Indexing Mechanism for a Type Point Contact
点接触式高速弧面分度凸轮机构的设计
9.
Tooth Contact Analysis and Cutting Parameters Modification of Small-modulus Spiral Bevel Gears;
小模数弧齿锥齿轮的接触分析与切削参数修正
10.
Roughness and contact angles of micro-arc oxidation coating on the surface of titanium
纯钛表面微弧氧化膜的粗糙度与接触角
11.
Discussion on Permanent Magnetic Actuator With Non-Plane Contact and Double-Acting Vacuum Interrupter
非平面接触永磁机构与双动式真空灭弧室探讨
12.
Geometrical Contact Analysis of the Flow-dividing Transmission System of an Arc-tooth Cone Gear
弧齿锥齿轮分流传动系统几何接触分析
13.
Transmission Analysis of an Arc Teeth Synchronous Belt Considering the Complex Contact Conditions
复杂接触条件下圆弧齿同步带啮合传动分析
14.
Image acquisition and pre-processing of spiral bevel gear contact spots
弧齿锥齿轮接触斑点图像采集及预处理
15.
The worn wheel tyre contact surface has a concave revolutionary curved form with two principal curvatures.
磨耗后的车轮接触面,是内凹圆弧的旋转形成面,有两种主曲率。
16.
Basom observed the contact angle of water against silane-treated E glass to be about 1. 2 rad.
巴索母观察到水对硅烷处理的E玻璃接触角大约是1．2弧度。
17.
Analysis of Dielectric Recovery Strength and Reignition Process in Iron Splitters Chambers of AC Contactor
接触器栅片灭弧室介质恢复强度及重燃过程的分析
18.
The working condition of circular-arc-tooth-trace (CATT) cylinder gear has certain effect on the contact zone between its tooth flanks.
外部条件对圆弧齿线圆柱的齿轮的齿面接触区产生一定影响.