1.
Experiment on tensile and shear strength of front fillet welded joint post-high-temperatures
高温后正面角焊缝抗拉剪切强度的试验
2.
Study of Length Calculation of Three Side Welded Lap;
三面围焊搭接角焊缝长度计算的探讨
3.
And the weld width decrease with welding speed being increased.
而焊接速度的增大,焊缝正面和背面的熔宽明显减小。
4.
STUDY ON FRONT SIDE ARC LIGHT SENSING IN KEYHOLE. MODE PLASMA ARC WELDING
穿孔等离子弧焊正面弧光传感技术研究
5.
Simulation research of soft switch APFC for welding
面向焊接的软开关有源功率因数校正仿真研究
6.
Penetration Control of GMAW Based on Multi-informational Fusion from the Front Surface
基于正面焊接多信息融合的GMAW熔透控制
7.
an octahedron with eight equilateral triangles as faces.
有八个正三角形面的八面体。
8.
a dodecahedron with twelve regular pentagons as faces.
有十二个正五角形面的十二面体。
9.
Both single and double fillet welds shall be as follows unless otherwise shown on the drawing.
除非图上另外标明，所有单、双面贴角焊缝高度如下。
10.
"Attempting to braze a contaminated or improperly cleaned surface will result in an unsatisfactory joint.
在已经弄脏或不正确清洗的表面上进行钎焊，焊接效果就很难令人满意，
11.
By enhancing welded construction's rigidity and both side alternative surfacing, the problem of tube plate deformation was solved.
采用提高刚性和正反面交替直道堆焊等方法解决了蒙乃尔合金换热器管板堆焊的变形问题。
12.
It will frequently be found desirable to use a double tip torch to maintain the proper temperature over the large area.
为了在整个大面积上保持正常的温度,通常情况下需要两个焊枪。
13.
Having faces that are congruent regular polygons and congruent polyhedral angles.Used of polyhedrons.
全等的每个面都是全等正多角形和全等多面角的。用于多面体
14.
Method for Unstructured Viscous Cartesian Grid
非结构粘性直角网格物面相贯线修正
15.
The Positive Aspect of the Internet as Viewed From a Librarian's Angle
从一个图书馆员的角度看网络的正面
16.
The box corner welds were made with E70 electrodes.
箱型梁内角部焊缝所用的电焊条为E70。
17.
Quality Control of the Fillet Weld in the Tube and Tube Sheet of Heat Exchanger
换热器管-管板角焊缝焊接质量的控制
18.
Effect of Welding Angle on Fatigue Performance of Welded Structure
焊接角度对焊接结构疲劳性能的影响