1.
Prediction Algorithm of Trim Beam Number Using Modified SVM-Based Feature Selection
基于SVM特征选择的整经轴数预测算法
2.
These beams may be produced either by beam or drum warping methods. If the yarn is to be used for warp knitting, it is usually ready at this point to go to knitting machine.
可以采用轴经整强经生产这类经轴。如果纱线用来供应经编机,至此便可直接供经编机使用。
3.
A propeller shaft that has been in use for a long period of time cannot be adjusteIf the length of the propeller is incorrect and causing vibration, replace the propeller shaft.
已经使用很长时间的传动轴不能调整。如果传动轴的长度不正确并引起振动，更换传动轴。
4.
Plain bearings-Shaft diameters for unsplit bushes
GB/T10445-1989滑动轴承整体轴套的轴径
5.
quick spindle adjustment
(钻床) 快速主轴调整
6.
axle drive pinion adjusting sleeve
车轴传动小齿轮调整套
7.
Improper adjustment of differential bearings.
差速器轴承调整错误。
8.
spring seat bearing adjusting nut
弹簧座轴承调整螺母
9.
wheel hub bearing adjusting nut
车轮毂轴承调整螺母
10.
differential adjusting wrench
分速分速器轴承调整扳手;分速器轴承调整扳手
11.
Each rotor core is visually inspected for complete filling of the die-cast end rings and fan blades.
每个转子芯都经过人工检查是否完整配置压铸轴承挡圈和风机叶片。
12.
Copper alloy integrated shaft sleeves--Technical requirements
GB/T2511-1981滑动轴承铜合金整体轴套技术条件
13.
INFLUENCE OF DIE STRUCTURE AND COINING MODE ON COAXALITY OF BEARINGS
模具结构及整形方式对轴承同轴度的影响
14.
The large scale bend axis piston pump axial setting and pump package centre adjusting method
大型斜轴泵轴线设置与泵组中心调整方法
15.
The door was off hinges.
门已经脱出了门轴。
16.
The swivel had been oiled to perfection.
旋轴已经上足了油。
17.
integral one-piece mainshaft
(多缸转子发动机用的) 整体式偏心轴
18.
adjustable self-aligning bearing
可调节的自动调整式轴承