1.
Loosen the compression nut tool.
放松压紧螺帽工具。
2.
lock nut of iron or stee
锁紧螺帽,防松螺帽,铁或钢制
3.
reverse anchor jam nut
反向锁闭机构紧固螺帽
4.
Adjust the nose of the ram to align the pointer with the SET mark on the scale of the tester and tighten the hex nut.
调整压头鼻，利用测试器标尺上设定的标记对齐指针，拧紧六角螺帽。
5.
Tighten glass track nuts to 6 N·m (in-lbs) torque.
拧紧玻璃轨道螺帽至6 N·m (in-lbs)扭力。
6.
Torquing Tie Rod End Attaching Nut
拧紧转向拉杆端接合螺帽
7.
Install the bushing by tightening the Long Nut.
通过扭紧长螺帽来安装衬套。
8.
Tighten wheel nuts until all are properly torqued, to eliminate brake distortion.
拧紧车轮螺帽直到所有螺帽都达到适当的扭力，以免刹车变形。
9.
"Bolts,screws & nuts"
"螺栓,螺丝及螺帽"
10.
Tighten the pressure regulator.
请拧紧压脚调节螺丝。
11.
bright mild steel hexagonal pressed nut
光亮软钢六角冲压螺丝帽
12.
Upper and lower welding heads-"oil bath"type with Hydraulic Nut.
上、下焊头(油池型)带液压螺帽
13.
Align the bushing with the spring eye or shackle eye and tighten the nut at the socket wrench end of the threaded roTighten until the bushing is forced into the spring eye.
将衬套对准弹簧眼或U型钩眼，并在螺纹杆的套筒板手末端锁紧螺帽。锁紧直到衬套进入簧眼。
14.
Install differential case and dummy bearings in axle housing (without shims) and tighten retaining cap bolts.
在轴壳内（没有垫片）安装差速箱和模型轴承，并紧固固定帽螺栓。
15.
hydraulicdevice for tightening tie-bolt
贯穿螺栓上紧用液压装置
16.
SLN self-locking nuts
SLN自动防松螺帽
17.
BRACKET MOUNTING NUTS
支架固定螺帽（2）
18.
hex machine screw nut
机械螺丝用六角螺帽