1.
Loosen but do not fully remove the four bolts that attach the stabilizer bar bushing retainers to the rear axle brackets.
松开但不完全拆卸接合稳定杆衬套扣环与后车轴支架的4支螺栓。
2.
Study on one step injection forming machine of screw pump stator lining
螺杆泵定子衬套一步法注射成型机的研究
3.
reaming and pushing machine for piston connecting rod bush
活塞连杆衬套铰压机
4.
Force-thermal coupling analysis numerical simulation for a double-helix single screw pump bush
双头单螺杆泵衬套力热耦合模拟研究
5.
Disconnect stabilizer bar links at the axle.
断开车轴上稳定杆连杆。
6.
Design of Warm Extrusion Process for Roughcast of Engine Connecting Rod Sleeve
车用发动机连杆衬套毛坯温挤工艺设计
7.
Align the bushing with the spring eye or shackle eye and tighten the nut at the socket wrench end of the threaded roTighten until the bushing is forced into the spring eye.
将衬套对准弹簧眼或U型钩眼，并在螺纹杆的套筒板手末端锁紧螺帽。锁紧直到衬套进入簧眼。
8.
Backseat– machined bonnet stem bushing provides back-up stem seal.
(10) 后座-经过精密加工的阀盖阀杆衬套实现后座阀杆密封。
9.
Backseat– machined bonnet backseat provides back-up stem seal.
(9) 后座-经过精密加工的阀盖阀杆衬套实现后座阀杆密封。
10.
Backseat ? machined bonnet stem bushing provides back-up stem seal.
后座-经过精密加工的阀盖阀杆衬套实现后座阀杆密封。
11.
Failure of Boiler Blower Fan Resulted from Bush Fixing
紧定衬套安装而导致的快锅风机问题
12.
Numerical Method of Unstable Heat Transfer in Unidimensional Furnace Lining (1)
一维炉衬不稳定态传热的数值计算(1)
13.
The substrates can be relatively close and stationary.
衬底可能是相当致密的和稳定的。
14.
A Study on Stability of Lining Structure for Plunge Pool with Inverted-arch Type;
反拱形水垫塘衬砌结构的稳定性研究
15.
The track bar connects the rear axle to the frame/body of the vehiclThe track bar is isolated from the body of the vehicle by an isloator bushing located in each end of the track bar.
横拉杆把后轴联结到车框或车体上。横拉杆用一安放在横拉杆两端的隔离衬套与车体隔离开。
16.
Analysis of Small End Bushing and Crosshead Pin Failure of Fresh Hydrogen Compressor Connecting Rod in Hydrocracking Unit
加氢裂化新氢压缩机连杆小头衬套与十字头销烧损原因分析
17.
Xiangshui Red Star Adapter Factory was founded in October2000 with the development of industrial.
响水县红星紧定衬套厂于2000年10月诞生。
18.
Sintered metal bushes--Determination of radial crushing strength
GB/T6804-1986烧结金属衬套径向压溃强度测定法