1.
Relations Between Flow Field and Pressure Fluctuation in Draft Tube of Francis Turbine
混流式水轮机尾水管进口流场与水压力脉动的关系
2.
Conical Column End for Wide Bore Packed Capillary Liquid Chromatographic Column
宽口径填充毛细管液相色谱柱柱尾结构的改进
3.
Three-Dimensional Flow Emulation Calculation Through a Hydraulic Turbine Draft Tube of Danjiangkou Expanding Units;
丹江口扩机尾水管三维流场仿真计算研究
4.
Design of upper water inlet/outlet penstock for Yixing Pumped-Storage Power Station
宜兴抽水蓄能电站上进/出水口压力钢管设计
5.
A projecting part with an opening, as at the end of a hose, for regulating and directing a flow of fluid.
管嘴，喷嘴管子等物件的尾端的带有开口的突起部分，用于控制和引导水流
6.
Study on the Proposal for the Application of Recycle Water from Tailing Dam in the Flotation Plant at HaiKou
海口浮选厂尾矿库回水利用方案探讨
7.
Put a straw in a glass of drinking water. Suck through the straw. The water goes up into your mouth.
把一根麦杆吸管插入一杯饮用水中，通过吸管吸，水就会进入口中。
8.
Relations between the Vortex and Pressure Fluctuation in Draft Tube of the Hydraulic Turbine;
水轮机尾水管涡带与压力脉动的关系
9.
Structural Design about Stern Structure of Deep and Shallow Water Pipelay Crane Vessel
深水/浅水铺管起重船尾部结构设计
10.
Study on improvement of hydrostatic testing method for long-distance and super-large diameter PCCP pipeline
长距离大口径PCCP管道水压试验方法改进研究
11.
Influence of inlet flow of collecting pipe shape on hydraulic characteristics for roto-jet pump
旋喷泵集流管进口形状对水力性能的影响
12.
Pig inlet &outlet and oil (air or water) inlet shall be connected respectively to the main pipe by valves.
收发球口和进油（气、水）口分别通过阀门与主管线连接。
13.
"Shut off the electric power supply to heater, close cold water inlet, open a hot water faucet to allow air to enter the system and open the drain valve, which is threaded to receive a standard hose coupling."
首先关闭电源开关,关闭冷水进口阀门,打开热水水龙头让空气进入管道系统,并且打开排水阀。
14.
steam generator water tank filler
蒸汽发生器水罐进水口
15.
To dip bow and stern alternately.
上下颠簸船头或船尾轮流扎进水
16.
A rear hatch cover had broken loose and water was flooding into the aft section.
后舱盖松裂，海水正涌进艇尾部。
17.
Experimental study on hydrodynamic performance of a bio-tail fin propulsive system
仿鱼尾鳍推进系统的水动力性能试验
18.
Shape Optimization of Vertical Pipe Inlet/Outlet and Research of Y-type Tube in Pumped-Storage Plant;
抽水蓄能电站竖井式进/出水口体型优化与“卜”型岔管研究