1.
cam shaft reversing lock
凸轮轴换向闭锁装置
2.
cam shaft driving gear
凸轮轴传动齿轮凸轮轴传动装置
3.
cam shaft drive
凸轮轴传动凸轮轴传动装置
4.
As the camshaft continues to rotate, the high spot moves way from the valve mechanism.
因为凸轮轴继续旋转，凸轮轴上的凸起部分离开气门装置。
5.
The camshaft also fits inside the block, except on overhead-cam engines( OHC).
除了顶置凸轮(HC)动机以外，凸轮轴都安装在气缸体里面。
6.
Machine tools--Spindle noses and face plates--Sizes for interchangeability--Part 2: Camlock type
GB/T5900.2-1997机床主轴端部与花盘互换性尺寸第2部分:凸轮锁紧型
7.
In other words, the regular side of the cam shaft and the fuel running of the main engine are interlocked with each other.
换句话说，凸轮轴的调油侧与主机的燃油运转是相互联锁的。
8.
overhead camshaft engine
上置式凸轮轴发动机
9.
Application of Hydraulic Lock in Turbine Blower
液压闭锁装置在汽轮鼓风机组中的应用
10.
It is not advisable to attempt to replace camshaft bearings unless special removal and installation tools are available.
不要试图更换凸轮轴轴承，除非能够使用特殊的拆卸和安装工具。
11.
Close the pivot cover and move the rear wiper blade to the Park position on the ramp.
关闭枢轴盖且移动后雨刷片至在凸轮滑道park（停止）位置。
12.
Replacing the camshaft requires about eight hours; four additional hours are required for replacing camshaft bearings.
更换凸轮轴需要8小时左右;更换凸轮轴轴承需要额外增加4小时。
13.
"With this arrangement, the camshaft is directly below the valve lifter, and no push rods or rocker arms are necessary. "
"在这种装置中,凸轮轴直接装在气门挺杆下,并且不必有推杆或摇臂。"
14.
blocking distance protection equipment
闭锁式距离保护装置
15.
Research on the Transverse Knurling Connection Mechanism of Assembled Camshaft and Numerical Analysis on the Press Mounting and Torsion Process
装配式凸轮轴横向滚花连接机理研究及压装扭转数值分析
16.
overhead cam shaft
上凸轮轴上部凸轮轴
17.
Analysis and calculation of cam templates interchangeability in camshaft grinder
凸轮轴磨床凸轮靠模互换的分析与计算
18.
Verify Crankshaft—Camshaft Installation—Typical
验证曲轴—凸轮轴安装—典型的