1.
The Relation, Substitution and Implement of Radial Run-out Tolerance and Axiality Tolerance;
径向跳动公差与同轴度公差的关系、取代及实施
2.
CAI bearings are of motor class bearings and the common tolerance is shown on the attached data sheet.
CAI轴承一般为电机级轴承，最常用的轴承公差精度见附表所示。
3.
Analysis on coaxiality of cutter adaptor and its guarantee measure
刀具接杆同轴度的误差分析及保证措施
4.
Minimum circumscribed circle finite element post-processing algorithm for coaxial error
同轴度误差最小包容圆有限元后处理算法
5.
Rolling bearings--Thrust ball bearings--Tolerances
GB/T307.4-1994滚动轴承推力球轴承公差
6.
Rolling bearings--Needle roller bearings-Track rollers--Tolerances
GB/T6445.2-1996滚动轴承滚轮滚针轴承公差
7.
Analysis & Solution of Oversize Error Problem During Measuring Coaxiality of Part with Short Reference Axis by CMM
坐标测量机测量短基准零件同轴度时误差过大问题的分析与解决
8.
The energy equations of the oil film and the bush are solved simultaneously by using an efficient finite difference scheme.
用一有效的有限差分法同时求解油膜和轴瓦的温度控制方程。
9.
A Kind of Coaxiality Measurement Method Unaffected by Installation Error
一种可消除安装误差影响的激光同轴度测量方法
10.
Analysis of the Cylindricity Tolerance and Press Mounting Curves of Axle Wheel Seat and Wheel Hub Bore
关于车轴轮座、车轮轮毂孔的圆柱度公差和压装曲线分析
11.
Meanwhile, the fracture was accelerated due to the uneven surface hardness and the unreasonable distribution of the hardening layer on the crankshaft, and the bad lubrication condition in service.
同时轴左颈表面硬度不均匀、淬硬层分布不甚合理，工作过程中润滑条件差，加速了曲轴的断裂。
12.
" Tolerance and fitting, dimensions up to 500mm holes, shaft tolerance range and fitting"
GB/T1801-1979公差与配合尺寸至500mm孔、轴公差带与配合
13.
" Tolerance and fitting, dimensions up to 18mm holes, shaft tolerance range"
GB/T1803-1979公差与配合尺寸至18mm孔、轴公差带
14.
falling coaxlal cylinder viscometer
同轴圆筒下落式粘度计
15.
falling coaxial cylinder viscometer
同轴圆筒下落粘度计
16.
Analysis on the Differences of Local Public School Students Attitudes towards Migrant Students;
公办中小学学生对借读同学的态度差异分析
17.
" Plain bearings-Thin-walled bearing shells-Dimensions, structure elements and tolerances"
GB/T3162-1991滑动轴承薄壁轴瓦尺寸、结构要素与公差
18.
main bearing aligning gauge
主轴承座孔同轴度检验仪