1.
An initial stopping location was not found in the program. To stop during program execution, first set a breakpoint and then start running the program.
程序中没有找到初始停止位置。要在程序执行过程中停止，需要设置断点后再开始运行程序。
2.
The two-moment description tells where the ions are located and roughly how broad the distribution is.
二阶矩描述给出了离子的停止位置，并粗略地给出分布的宽度。
3.
This line diagram has been drawn up on the condition that the main engine remains stopped at astern side and that control air has been blown off.
这图画于主机停留在停止位置后退方向及控制空气已经放出的状况。
4.
Compressing the spring rod, the linkage connected mechanically to the rod of the single-acting cylinder turns the fuel regulating shaft to the stop position.
压缩弹簧杆，联动装置机械连接到单作用汽缸的杆上转动燃油调节杆到停止位置。
5.
Device for preventing the mechanism from stopping in a dead center position.
一种防止机械装置在死点位置停止的装置。
6.
SET BAUD RATE, PARITY, WORD SIZE, AND STOP BITS.
//设置波特率,奇偶效验,数据位,停止位.
7.
Wipers Not Parking in the Off Position
雨刷在关闭位置不能停止
8.
Drag onto the page to add a device for preventing the mechanism from stopping in the dead center position.
拖到绘图页后，可以添加一种防止机械装置在死点位置停止的装置。
9.
Receive Location '{0}' has Start Date later than the Stop Date. Change either the Start Date or the Stop Date.
接收位置“{0}”的开始日期晚于停止日期。请更改开始日期或停止日期。
10.
A place in a program where execution is stopped because of an error.
程序中的一位置,在此位置上由于出错而使执行停止。
11.
Specifies a bitmask indicating the stop bit and parity settings that can be selected.
指定表示可以选择的停止位和奇偶校验设置的位掩码。
12.
station and stopping location
停车站和停车点的位置
13.
A parking brake system can prevent the auto slipping away from its parking place, even if it is parked on a steep slope.
而驻车制动系则可以防止停放的汽车脱离停车位置，即便它是停在一个很陡的坡度上。
14.
go into retirement; stop performing one's work or withdraw from one's position.
引退；停止履行某人的工作或从某的的位置上退出。
15.
Snowplow: Position skis tips together, being careful not to cross.
之间靠前的位置，用滑雪板的内刃卡住雪面，直到完全停止。
16.
Close the pivot cover and move the rear wiper blade to the Park position on the ramp.
关闭枢轴盖且移动后雨刷片至在凸轮滑道park（停止）位置。
17.
The machine runs in the wrong direction during slow motion or pickfinding.The movement is immediately stopped.
在慢速运动或找纬时,机器运行到错误的位置,动作将马上停止.
18.
You are asked to remain seated with safety belts fastened and with seats in an upright position until the aircraft has come to a complete halt.
请您留在座位坐好，并系好安全带，椅背保持直立位置，直到飞机完全停稳为止。